Aleko AWRCLED Series Specification

Pair Additional Remote
One motor can be paired to 20 remotes/sensors in total, follow below steps to add a new remote
→ →
P2 P2 P2
P2(a) P2(a) P2(b)
Remove All Remotes
→ →
P2 P2
P2 STOP P2
8307 S 192nd St Kent, WA 98032
Phone: 888-246-8596 or 253-246-8222
hello@alekoproducts.com
www.Aleko.com
Press P2 (1 beep and 1 jog) and P2 (1 beep and
1 jog) on existing emitter, press P2 on new emitter
to add (beeps multiple and 1 jog), new emitter is
paired to the motor.
Press P2 (1 beep and 1 jog), STOP (1 beep and
1 jog), and P2 (beeps multiple and 1 jog), all
emitters are deleted.
433MHz & 868MHz & 315MHz
DC3V/23A & 3V/CR2430
Specific parameters to the nameplate shall prevail
AWRCLED Series Control System
Specification
Up button
Stop button
Down button
LED control
button
AWRCLED
LED Control：
Press LED control button once,it will turn on the LED to 50% brightness. Press the button
again will turn the LED to 100% brightness.Press the button once again,it will turn off the LED.
AWRCLED series：AWRCLED
DC3V/CR2430
(AWRCLED)
Setting Up Manual
The setting steps are different for left facing mounted motor and right facing mounted motor.
Carefully check which side you have mounted the motor and follow the correct setting steps.
Setting button P2
AWRCLED Back