Advertisement
Quick Links
Guard Kit
TimeCutter
Model No. 74130
Model No. 74134
Do not supply these instructions to the customer.
These instructions are for a dealer to install additional belt
guards on units sold in France.
This product contains a chemical or chemicals known to the State of California to
Safety
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located near any area of potential
danger. Replace any decal that is damaged or lost.
Model 74130 only
1. Thrown object hazard—keep bystanders a safe distance
from the machine.
2. Thrown object hazard, mower—do not operate without the
deflector, discharge cover, or grass collection system in
place.
3. Cutting/dismemberment of hand or foot—stay away from
moving parts.
© 2013—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Riding Mower with 81cm or 127cm Cutting Unit
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
110-6691
Register at www.Toro.com.
WARNING
CALIFORNIA
1. Entanglement hazard, belt—keep all guards in place.
1. Fire hazard—read the Operator's Manual.
Form No. 3381-538 Rev A
Installation Instructions
114-1606
Model 74130 only
120-1119
Original Instructions (EN)
All Rights Reserved *3381-538* A
Printed in the USA.
Advertisement
Related Manuals for Toro TimeCutter 74130
Summary of Contents for Toro TimeCutter 74130
- Page 1 3. Cutting/dismemberment of hand or foot—stay away from 120-1119 moving parts. 1. Fire hazard—read the Operator's Manual. © 2013—The Toro® Company Register at www.Toro.com. Original Instructions (EN) All Rights Reserved *3381-538* A 8111 Lyndale Avenue South Printed in the USA.
- Page 2 Preparing for Installation No Parts Required Procedure Important: Refer to the Operator’s Manual if you are unfamiliar with the specifics of operating this machine before proceeding. The manual contains important information about safely operating the machine. If you do not know this information, you could seriously injure yourself or others.
- Page 3 Installing the Deck Belt Guard Parts needed for this procedure: Bolt (1.25 mm) Washer Locknut (1.25 mm) Procedure Figure 4 Model 74134 1. Loosen, but do not remove, the nut on the outside of each suspension bracket on the rear of the deck (refer 1.
- Page 4 g02461 1 Figure 7 1. bolt heads 2. guard plate Figure 6 Model 74134 3. Verify that the guard is clear of all moving parts, wires, hoses, and other components so that it will not 1. Washer 4. Rear slots interfere with the safe operation of the machine.