Delta HL6002 Assembly Instructions

Smartphone
Holder
Assembly instructions
Parts
A x1 — Phone Holder
B
x1 — Bungee
C
x1 — Handlebar Clamp
D
x1 — 360° Mount
E
x2 — Rubber Shim
F
x1 — Thumb Screw
G
x1 — Short Bolt
H
x1 — Stem Mount
I
x6 — Foam Inserts
Tool Required
Phillips Head Screwdriver
Using the Stem Mount
Remove existing stem cap from bicycle. Use existing stem bolt to install
1
Smartphone Holder stem mount (Part H) on to your bicycle stem.
NOTE: for landscape orientation install the stem mount as shown in
FIGURE 1
Connect phone holder to stem mount using short bolt (Part G) and
2
adjust angle before full tightening. If necessary use the adhesive foam
inserts (Part I) to provide a snug fit for your device. (FIGURE 2)
1
STEM BOLT
IMPORTANT SAFETY NOTE
Never loosen the stem clamp bolts.
WARNING
Using phone device while riding can cause accidents resulting in serious injury.
Important: Nuts and bolts can loosen over time, resulting in serious danger should the item fall off while in motion.
Check frequently to ensure all bolts are properly tightened. Ensure the device fits snugly in the holder before riding.
Not for off-road use.
HL6002/HL6500
HANDLEBAR CLIP OPTION
C
E
F
Assembly video
Visit designbydelta.com/downloads
B
2
A
STEM MOUNT OPTION
D
G H I
(for landscape
orientation)