Advertisement
Using the Handlebar Clamp with 360° Rotation
Connect 360° Mount (Part D) to rear of phone holder
1
using Short Bolt (Part G)
Use thumb screw; tighten to secure the
3
handlebar clamp and mount.
If necessary use the adhesive foam inserts to
provide a snug fit for your device. (FIGURE 2)
Delta Cycle Corporation
36 York Avenue, Randolph, MA 02368 USA
800-474-6615 / www.designbydelta.com
FIGURE 1
IMPORTANT
SAFETY NOTE
Do not attach clamp
to any tapered section
of your handlebar.
Use rubber shims as needed (Part E) (FIGURE 1)
2
Place Handlebar Mount (Part C) in position
over the 360° Mount (Part D), be sure groves
are in lined up and in place. (FIGURE 2)
How to use the 360° Rotation feature
360
°
To adjust the angle of the phone holder loosen
1
thumb screw. Pull the phone holder up slightly
so grooves are separated Rotate phone holder
into desired position. Once in place, tighten the
thumb screw.
Service:
Please do not return to store;
for immediate response email
service@designbydelta.com
FIGURE 2
011722
Advertisement
