Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Perma NOVA
Summary of Contents for Perma NOVA
- Page 1 NOVA Installation Guide The Expert in Lubrication Solutions...
- Page 2 © 2022 perma-tec GmbH & Co. KG The content of this document has been compiled by perma-tec with meticulous care. Nevertheless, we cannot rule out deviations and reserve the right to make technical changes to the product without any advance notice. We do not assume any judicial responsibility or liability for any damages which may ensue as a result.
- Page 3 / hoses, brackets and other accessories. See our product catalogue for the entire overview on perma accessories. • Ensure that the lube po int is prefilled with fresh lubricant before installation. perma offers all of its lubricants in 400 g cartridges for grease guns.
-
Page 4: Mounting Types
Direct mounting should be preferred for all lubrication points, to protect the lubrication system against high pressure. Reducer for thread connection Indoors, perma NOVA can be installed in any mounting position. Outdoors or in moist areas, mounting position must be vertical (outlet pointing down) or horizontal! 360°... - Page 5 Keep in mind that tube / hose length and bore diameter of bearing housings affect pressure and discharge period of the lubrication system. • For installation of perma NOVA use Mounting bracket 1-point G1/4 female (109685). • Secure tubes / hoses with suitable fastenings (brackets, cable ties) to protect against damage and tearing.
-
Page 6: Remote Mounting
Loctite® 243™ Direct mounting All oil filled perma NOVA come with an integrated oil retaining valve. They can be installed directly on a lubrication brush without the need for an additional oil valve. Insert for bracket G1/4 male x G1/4 female... - Page 7 2. Remove grease nipple or plug screw of connecting thread and check thread size. Determine thread size at the lubrication point with perma fitting thread tester Art. No. 110374 3. Insert reducer and install tube / hose and necessary accessory parts. © 2022 | perma-tec GmbH & Co. KG | www.perma-tec.com |...
- Page 8 4. Lubrication point, accessory parts and tubes / hoses must be pre-filled with lubricant. This enables the lubricant to immediately reach the lubrication point. Grease gun (101455) Hose with rotary joint, slide and hydraulic coupling for grease gun (110199) Tube prefill adapter 5.
-
Page 9: Pressure Testing
Pressure testing Check counter pressure at lubrication point before installing the lubrication system to guarantee correct function. Most bearings require 0.5 - 2 bar pressure (without extension tubes / hoses). perma NOVA can be used for these lubrication points. perma STAR VARIO... - Page 10 (Caution: Observe accident prevention regulations). 5. Open stop valve. 6. Push SET button on perma STAR VARIO for approx. 10 seconds until PU lights up on display to trigger an additional discharge / purge. 7. Watch the pressure on the gauge during the additional discharge. If pressure exceeds 7.5 bar the lubrication system will shut off automatically.
-
Page 11: Activation And Installation
125 cm³ / 4.23 fl.oz. (US) Installation date and exchange date Art. No. | Serial number (to be added by operator) (product designation – year / week of manufacture – internal no.) Lubricant designation © 2022 | perma-tec GmbH & Co. KG | www.perma-tec.com |... - Page 12 GmbH & Co. KG Hammelburger Str. 21 97717 Euerdorf GERMANY Tel.: +49 9704 609 - 0 info@perma-tec.com www.perma-tec.com...