Universal Furniture Universal explore home Paradox 827-310 Instruction Sheet

827-310/31F/31R
827-320/32F/32R
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
PARTS LIST:
the furniture properly and kept tightened at all times.
# Description
A Headboard
Assembly Procedure
C Side Rail
E Support Leg
Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2: put all parts on a soft and smooth surface to avoid damage or being scratched. Insert bolts (5)
into the headboard, and then attach the rails to the headboard and footboard with nuts (1),
spring washers (2) , curved washers (3) and flat washer (4) using wrench (7) to tighten them.
Step 3: Attach center support legs onto slats. Screw slats onto side rails with screwdriver (not
provided). There are three slats, please distribute each space evenly. Adjust height of center
support legs with screw adjustment.
Assembly is now complete.
Note : When you are assembling King Bed, refer to the steps of King Bed. Queen bed have three center
supports and King bed have six center supports.
INSTRUCTION SHEET
Qty. #
1pc B
2pcs D
6pcs F
: (Please follow the sketches below.)
Paradox Bed 6/6 5/0
Description
Footboard
Slat
Hardware Pack
Qty.
1pc
3pcs
1bag