Dimplex DFH 22 Operating Instructions Manual page 7

DFH 22
ATTENTION!
The socket-outlet must be accessible at all
times to enable the mains plug to be discon-
nected as quickly as possible!
ATTENTION!
Do not use extension cables to connect the
heating device, as this could result in fire in
the event of overheating!
NOTE
Repairs and corrective measures must only be carried
out by a qualified technician.
NOTE
Use device for room heating within enclosed rooms
only.
NOTE
Disconnect the power supply in the event of fault or
when device is not used for an extended period of
time.
2. Installation
ATTENTION!
Do not install the device directly below a wall
socket.
ATTENTION!
The fan heater may only be used as shown,
i.e. on a horizontal, even surface. Use on
deep-pile carpets is not permitted. Minimum
clearance in the air outlet area: 750 mm.
3. Electrical connection
Only connect the device to the AC voltage power sup-
ply as specified on the type plate.
www.dimplex.eu
4. Operation
1
5
1 Thermostat control rotary knob 4 Safety toggle switch
2 Indicator lamp
3 Operating mode rotary knob
Operating mode rotary knob
Thermostat control rotary knob
the thermostat control rotary knob slowly to the left
until the device switches off. The device now switches
on and off automatically to maintain the desired room
temperature. There may be an audible click during
this process.
If the thermostat rotary knob is set to the lowest set-
ting i.e. to the extreme left, the thermostat switches
the heating device on at an ambient temperature of
approx. 5 °C.
Using the operating mode rotary knob, two heating
levels and a cold air level can be selected.
In the cold air fan operation, turn the thermostat ro-
tary knob to the right stop (maximum).
The device is equipped with a safety toggle switch.
The device switches off automatically if it is not in its
correct position.
2205/A
2
3
4
5 Air outlet
Off
Cold air
Heating level 1 (800 W)
Heating level 2 (2000 W)
The room temperature is regulated
using the continuously adjustable
thermostat.
Turn the thermostat control rotary
knob to the right stop at the start
(maximum). When the desired
room temperature is reached, turn
English
EN-7