Download Print this page

San Jamar SN46 Quick Start Manual

Classic soap dispenser

Advertisement

Quick Links

Opening the Dispenser:
1. Remove key that is taped to the bottom of the dispenser.
2. Insert key into slot on top of the dispenser until there is a
click.
3. Use 2 hands to pull cap up and off the dispenser.
Mounting the Dispenser:
1. Remove the cap by inserting the key into the top of the cap
until there is a "click" then pull the cap upwards with two
hands.
2. Press the tab holding the backplate in place and slide back-
plate down and off.
3A. (If using a level to mount the dispenser) Using a level, place
backplate on wall in the area to be mounted and mark the 3
hole locations.
3B. (If no level is available) Place backplate on wall in the area
to be mounted and mark the upper hole location. Hang the
dispenser from this single hole using supplied fasteners. Mark
the other 2 hole locations.
4. Drill holes and insert wall anchors (if used).
5. Mount backplate using the supplied fasteners.
6. Attach dispenser housing to backplate by holding the dis-
penser against the wall above the backplate and sliding the
dispenser downward until there is a "click".
7. Install the cap by holding the cap against the wall above the
dispenser housing and sliding down until there is a "click".
Filling:
1. Remove cap by inserting key into slot in cap and pulling the
cap upwards with 2 hands.
2. Fill the dispenser with liquid soap or sanitizer.
3. Replace cap by holding against wall above the dispenser
housing and sliding downward until there is a "click".
4. It will take 4-8 strokes to prime the pump.
5. The dispenser is now ready for use.
6. DISCLAIMER: Soap containing scrubbers or abrasives will
cause the dispenser to leak or eventually fail. San Jamar is
not responsible for incorrect soap use that leads to faulty
dispenser operation or clogging. Use Liquid/Lotion soap.
SN46 Classic Soap Dispenser
San Jamar
Canada
555 Koopman Lane
3280 Bloor Street West
Elkhorn, Wisconsin 53121
Suite 1140
USA
11th Floor, Centre Tower
T: +1.262.723.6133
Toronto, ON M8X 2X3
F: +1.262.226.8664
CANADA
info@sanjamar.com
T: +1.262.723.6133
www.sanjamar.com
F: +1.262.226.8664
canada@sanjamar.com
© Copyright San Jamar, Inc. 2022
1
1
3B
6
Dispenser Activation
1. Push the lever located at the bottom, center of the cover.
Press with palm facing up
and fingers curled under
the dispenser
1
Maintenance:
Periodically give the dispenser an overall cleaning – including
internal and external parts.
Europe
México
Schoorstraat 26a, bus I
Av. Paseo de la Reforma No. 350 - 10
2220 Heist-op-den-Berg
Col. Juarez
BELGIUM
Deleg. Cuauhtemoc, CP 06600
T: +32 15 22 81 40
MEXICO, D.F.
F: +32 15 22 81 48
T: +52 (55) 3626 0772
emea@sanjamar.com
mexico@sanjamar.com
2
3
2
4
5
7
7
105026SJ
3A

Advertisement

loading

Summary of Contents for San Jamar SN46

  • Page 1 5. The dispenser is now ready for use. 6. DISCLAIMER: Soap containing scrubbers or abrasives will cause the dispenser to leak or eventually fail. San Jamar is Maintenance: not responsible for incorrect soap use that leads to faulty dispenser operation or clogging.
  • Page 2 SN46 Classic Soap Dispenser Abra el dispensador: Ouvrir le distributeur : 1. Retire la llave pegada en la parte 1. Retirez la clé collée au bas du inferior del dispensador. distributeur. 2. Inserte la llave en la ranura en la 2.

This manual is also suitable for:

Sn46tbk