Summary of Contents for Halma Ampac MAN3053-1
- Page 1 Fire detection and evacuation solutions that save lives. Zone Input Device Installation guide MAN3053-1...
-
Page 2: Installation
MAN3053-1 Description The Zone Input Device is available in two variants: The DIN-Rail Mounted Zone Input Device, Item No 4210-0058, is designed to be mounted in an enclosure, clipped onto a standard 35mm DIN Rail (DIN46277) and secured using the built in fixing. End stops can also be used to provide additional security. -
Page 3: Schematic Diagram
MAN3053-1 Schematic Diagram Programming When configuring the Zone Input Device for use with the FireFinder range of panels, using ConfigManager the device is assigned as an AMPAC ZID type. When configuring for use with LoopSense range of panels, using LoopMaster the device is configured as an XP95 Zone Monitor Unit. The Zone Input Device can be programmed to function in any one of the following modes: •... -
Page 4: Led Indications
MAN3053-1 Maximum Loop Current Consumption Max Current at 24V DC 10uF Quiescent Current 7.5mA Alarm Current 23mA 23mA 23mA (No Detectors connected and LED Polling disabled Polling LED Indication – adds 2mA Remote LED activation – adds 2mA when active LED Indications The Zone Input Device has three onboard LEDs which can be enabled and disabled using switch 4 on the 4 way DIL switch. -
Page 5: Fault Finding
MAN3053-1 Fault Finding Symptom Possible Cause No response Incorrect address setting Incorrect loop wiring Fault condition reported Incorrect input wiring Incorrect EOL resistor fitted Analogue value unstable Dual address Loop data fault Data corruption Constant alarm Incorrect input wiring Incorrect EOL fitted Incorrect control panel software Wiring Diagrams Series 65 Standard Base connection details –... - Page 6 MAN3053-1 Table 2 – Zone Input Device DIL Switch Settings The address of the Zone Input Device is set using the first seven switches of the 8 way DIL switch (marked address) DIL switch setting DIL switch setting DIL switch setting DIL switch setting DIL switch setting Address...