Advertisement
TDElectronics
Sound intensity: 100~110dB
Cable inlet: G1/2"
Sound type: fire sound
Gross weight: about 1.6kg
Appearance and Dimension
Operation
Testing: The end user should test the device after unpacking the
shipping carton. Testing guidance is as follows:
Connect DC24V wires to the power terminals in the siren and power
in on, it's qualified if the device give an audible alarm.
When the siren is connected to fire alarm system, the testing wires
User Manual of Explosion Proof Fire Alarm Siren TDE-SIREN-EX
F 向旋转
Figure 1
should be removed, and use an at least S
area rubber cable to connect it , otherwise, the detector will lose its
explosion-proof performance.
Installation: Use M6 bolts to fix the siren through its mounting rack
to the wall or ceiling.
Connection: Loosen the fixing screws of the siren bottom cover, open
the wiring chamber, connect the cables to the wiring terminals (see
the figure below). After connecting the wires, install the cover and
main body.
D
D
Precaution
1. It is strictly forbidden to disassemble the electrified device in
inflammable and explosive places.
2. Keep the explosion proof base clean and dry, be careful not to
damage it during installation. The fastening screws of the
explosion-proof base should be tightened. Be careful not to mix
foreign objects on the explosion-proof base.
3. If the device is in long-term use, please maintain it regularly, make
sure the device is in good condition and with good performance.
Please give to professionals for repair if the device has any failure or
damage.
Version: 20210314001AS
2
8 mm
cross-sectional
≥
D and D is for DC24V power terminal
Figure 2
Advertisement
