Appendix 1: Configuring The Com35 For A Dynamic Arc Flash Mitigation Application - Siemens COM35 Quick Start Manual

powerconfig |

Quick Start Guide

How to configure a new COM35 with powerconfig

Appendix 1: Configuring the COM35 for a Dynamic Arc Flash Mitigation application

Prerequisite: The COM35 module is connected to a network, has an IP address and can be communicated with.

Once a COM35 has been given an IP address and can be communicated with, the first step is to load the COM35 parameters to the

PC. Click on the Load to PC button and the breaker and communication parameters will be loaded into powerconfig.

The screen will have the connected breaker information on it:

Scroll down until Configurable I/O module is visible. The currently configured state of the Com digital input and Com digital output

will be shown.

Table of Contents