Advertisement
Available languages
Available languages
Replacement of the grinding controller
Insert the plate key between the plate and brake seal to hold the nut.
o
Rotate the plate counterclockwise to remove it.
o
Assemble the new plate and tighten it. Attention! The use of an original sanding disc is
o
recommended!
Remove the plate key
o
Fastening of grinding accessories
To attach the sandpaper, press the adhesive side of the paper against the sanding disc.
Note: If the adhesion of the sandpaper surface weakens, it may detach from the sanding disc and
injure the operator. Then the grinding disc should be replaced.
Dusk extraction
The device is not supplied with its own suction device, but you should always work with the vacuum
cleaner, as dust is hazardous to health. Connect a vacuum cleaner with a 40 mm diameter pipe and
use an antistatic pipe to reduce the electrical charge. Note: When disposing of hazardous dust,
observe local regulations.
Advertisement
