Advertisement
GSM Modem
UCM-93/2
DESCRIPTION
The UCM-93/2 industrial dualband GSM modem is a terminal for data transmission, fax and short message service (SMS) over
the GSM Network. The modem is designed for industrial telemetry applications. UCM-93/2 radio engine is fully type approved
according to several international specifications and are therefor applicable to use all over the world.
Serial RS232 interface with remote control by AT commands for dedicated applications.
The GSM modem is designed in an aluminium housing for DIN rail mounting. Supply voltage is 12-48VDC. A LED on the front
indicates the operating mode.
The SIM card slot and FME antenna connector is placed on the top of the module.
UCM-93.924
Antenna
SIM Card
12-48V
COM1
Antenna
SIM Card
12-48V =
Power
UCM-93.924/2
VERSIONS/ORDERING CODE
UCM- 93.924 /2
Type
Modem
UCM
Type no
GSM data modem
93
12-48VDC
924
Wavecom embedded engine
/2
Note: Antenna has to be ordered seperately.
1
40248 11_10
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Brodersen UCM-93/2
- Page 1 UCM-93/2 DESCRIPTION The UCM-93/2 industrial dualband GSM modem is a terminal for data transmission, fax and short message service (SMS) over the GSM Network. The modem is designed for industrial telemetry applications. UCM-93/2 radio engine is fully type approved according to several international specifications and are therefor applicable to use all over the world.
- Page 2 GSM Modem UCM-93/2 Connecting and wiring the UCM-93/2 Place your GSM -enabled SIM card in the SIM card slot. See the figure of direction of the SIM card below. Press gently the SIM card down till you feel a small “click” and the SIM card is fixed. (The SIM card is removed again by pressing it down till it is released).
- Page 3 Audio signal will not be available in UCM-93/2. If the UCM-93/2 has to be used with RTU-modules the PIN code must be disabled before use. Can be done with a normal mobile GSM cellular phone or with a PC with a terminal program and the AT command AT+CPIN=XXXX.
Need help?
Do you have a question about the UCM-93/2 and is the answer not in the manual?
Questions and answers