Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for TriMark 60-250
- Page 1 60-250 Travel Trailer Latch With Dead Bolt 60-251 Trailer Latch With Dead Bolt S S e e r r v v i i c c e e M M a a n n u u a a l l ( ( I I n n s s t t a a l l l l a a t t i i o o n n a a n n d d T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g ) )
- Page 2 4. STRIKE ADJUSTMENT 5. BASIC OPERATION 6. TROUBLESHOOTING Mounting Screws Required 1. BASIC COMPONENTS Total Door Screw TriMark For installing the 60-251 Travel Trailer Latch, Thickness Length Part # the following will be needed (Fig. 1): 1.25 /1.375 .625 15553-01 •...
- Page 3 B. Caulk or butyl tape. Apply caulk or 3. INSTALLATION OF LATCH butyl tape to the underside of the INSERTING OUTSIDE PADDLE flange all the way around (Fig. 5). A ASSEMBLY INTO DOOR (Figs. 3 thru 8) recess is provided around three 1.
- Page 4 3. Finish inserting the outside paddle assembly into the cutout as shown (Fig. 8). Fig. 8 SECURING THE INSIDE PADDLE ASSEMBLY TO THE OUTSIDE PADDLE ASSEMBLY (FIG. 9) SECURING LATCH TO DOOR EDGE Make sure the inside paddle is pushed in (FIG.
- Page 5 OPERATION OF THE PADDLE LOCK: 4. STRIKE ADJUSTMENT The paddle can be locked by rotating the Carefully close door. Door should easily latch lock cylinder in the paddle clockwise 1/4 shut. If door does not shut tightly enough for turn and can be unlocked by rotating the desired sealing, adjust strike as follows: lock cylinder counterclockwise 1/4 turn.
- Page 6 6. TROUBLESHOOTING SYMPTOM PROBLEM POSSIBLE REMEDY Door won’t latch shut Deadbolt is extended (locked) Unlock deadbolt Strike plate is adjusted too far inward Adjust strike plate outward Strike plate is installed with lip towards Remove and re-install strike plate correctly inside instead of outside of door Inside paddle assembly was not Remove and re-install inside plate correctly...
Need help?
Do you have a question about the 60-250 and is the answer not in the manual?
Questions and answers