Advertisement
Technical Information Sheet
4. Re-use
The spray gun and rubber hose have a long service life if properly maintained and can be re-used once the
canister is empty.
▪
Close the valve of the empty canister and remove the pressure in the hose depressing the spray gun trigger (2) for at
least 10 seconds.
▪
Close the adjustment screw (1) completely and disconnect the hose from the canister.
▪
Connect the hose to the new canister immediately and tighten the connection.
▪
Open the valve on the new canister slowly and squeeze the trigger (2) to remove all air from the kit.
5. Control
▪
Check guns, hoses, and connections daily and replace worn or damaged parts immediately.
▪
Close the valve on the canister if there is no adhesive coming out of the spray equipment.
▪
Disconnect the gun from the hose and open the valve of the canister slowly to check if the adhesive flows out of the
hose.
▪
Follow the cleaning procedure below to dissolve any dried adhesive.
6. Cleaning
▪
Before disassembly or removal of any part of the gun or attached components, close the valve of the canister and
release the pressure by depressing the trigger (2). Never assume that the system pressure is zero.
▪
Firestone recommends cleaning the nozzle (3) immediately after application of the adhesive. This can be done by
spraying Firestone Cleaner C-20 on the nozzle.
▪
All nozzles are precision made and should be handled with care. Loosen the nozzle and apply Firestone Cleaner C-20.
When heavier cleaning is required, leave it to soak in solvent to dissolve any dried adhesive. Use only solvents that
are suitable to clean metal, such as Firestone Cleaner C-20 or synthetic solvents.
▪
Do not poke any of the holes in the nozzle with metal instruments. If poking is necessary, use only soft tools or a
clean cotton cloth.
▪
The spray gun and rubber hose can be immersed for half an hour in synthetic solvents to dissolve dried adhesive.
7. Packaging
•
Packaging
•
•
Part Numbers
•
This document replaces any other document published previously. This sheet is meant to highlight Firestone product information based on the latest knowledge and experience and is subject to change
without notice (check the Firestone website for the latest document version). Above mentioned values are based on tested samples and may vary within applicable tolerances. Firestone takes responsibility
for furnishing quality materials which meet published Firestone product specifications. No Firestone representative is authorized to vary this disclaimer.
1 gun/carton
1 hose/bag
W563581082P – Spraying gun with 60 cm extension
W563581081 – 4.0m long hose
T. +32 (0)2 711 44 50
Firestone Building Products EMEA
I
F. +32 (0)2 721 27 18
I
Ikaroslaan 75
I
1930 Zaventem
I
E. info@fbpe.be
I
www.firestonebpe.com
I
Belgium
Advertisement
