Satco Nuvo 65-497 Installation And Safety Instructions

LED LINEAR HIGH BAY PENDANT
MOUNT/SURFACE MOUNT KIT
Models: 65-497
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING:
Risk of Fire or Electric Shock
• To avoid damage, falling, electric shock or fire, do not modify the fixture or replace accessories without confirming with
the supplier first.
• Only authorized, qualified personnel should install this fixture and should follow the owner's manual. Any improper
installation might cause failure, electric shock, fire or other injury, damage or hazard.
• Disconnect power before installation or any maintenance of the fixture.
• Do not dismantle the fixture without the supplier's authorization.
• Do not touch the power supply when the fixture is operating.
• Thermal insulating material is not allowed to cover the fixture.
• Please keep away from the corrosive substance, and keep the fixture dry and clean.
• The external flexible cable or cord of this fixture cannot be replaced; if the cord is damaged, the fixture shall be destroyed.
• The electrical fitting must be installed by a licensed electrician.
• For use in environments where an accumulation of non-conductive dust on the fixture may be expected.
IMPORTANT:
This product must be installed in accordance with the applicable installation code by a person familiar
with the construction and operation of the product and the hazards involved.

INSTALLATION

NOTE: Accessories include mounting brackets and four bolts (C). Durable and practical steel construction with powder
coat finish. Fits Linear High Bay Models: 65-501, 65-502, 65-503, 65-504, 65-505, 65-506, 65-507, 65-508
1. Secure mounting bracket onto the ceiling using appropriate
hardware according to the installation surface, hardware A
and B not included.
A Anchors
B Screws
2. Connect wiring using knockout on
access plate. Follow Wiring Diagram
below.

WIRING DIAGRAM

Black (Line)
TO SOURCE
120-227V White (Neutral)
120-347V
Green (Ground)
347-480V
© Copyright 2020 Satco Products, Inc. 3/20
Ceiling
C
OUT
IN
DIMMING
FIXTURE
Purple (Dim +)
Gray (Dim –)
3. Install side cover plates using provided
hardware C.
C
4. Attach fixture to mounting bracket.
Installation is complete.
Satco Products, Inc.
Brentwood, NY 11717