Summary of Contents for LEGO Lamborghin Sian FKP 37
Page 1
Power Functions for Lamborghini Sián FKP 37 #42115 only applicable to LEGO lambo or lambo with the same instructions please read carefully and continue to assemble and modify according to the following tutorial 1. The color of some accessories may be different from that of the tutorial, please follow the actual object.
Page 2
Continue to assemble according to instructions 9-12, and change a gear in step 13 This gear needs changing Continue to assemble according to the instructions 14-44, and the changes required in step 45 are as follows:...
Page 10
Continue assembly of 12 Gear flush with motor hole...
Page 16
The following step number can be ignored an can be assembled in sequence Assemble it here, stack and install the motor wire head on the lithium battery to test whether it can rotate normally, and then continue to assemble...
Page 17
Link the two parts together! √√ ○ ollow the above tutorial to install without change But There are 2 errors in the following electronic pictures. Electronic pictures need be ignored here. Please pay attention to 2 "X" points 1.Red differential cancelled in the following steps. Refer to the above figure 2.
Page 33
Assemble 189-205 according to the instructions...
Page 35
Install here, pull the motor wire head superposition to the copilot for trial installation of lithium battery, and test whether the wheel can rotate When the shift module is pushed forward, the engine can run together No problem with the function test. Continue to assemble according to the following tutorial...
Page 45
Change the 1-unit fixings of this part to 2-unit fittings...
Page 46
Push the shaft at the front towards the rear Link the front and rear main bodies, and pay attention to the alignment of the four hole positions!
Page 47
Pay attention to push the shaft in to connect the front and rear...
Page 50
After fitting, install 4 wheels to test whether the car can move forward and backward normally Using the extension cable, click on the line head of the XL motor to stack, and connect the extension cable to the vehicle head. After that, place the lithium battery in the front of the vehicle...
Page 54
The servo motor can be installed only when both sides of the wheel are parallel and centered, and the cross hole of the gear on the serrated shaft is positive cross!
Page 58
Please install the lithium battery here, continue to test the car's functions, forward and backward, turn left and right...
Page 59
1.Assemble according to step 276 of the manual to step 282 (283-296 do not assemble) 2.Assemble according to step 297 of the manual to step 301-302. One red bolt is not installed (303-317 not assembled) Assemble according to the instructions from step 318 to step 322-323. One red bolt is not installed...
Page 60
1.Assemble according to step 324 of the manual to step 333 (334-336 do not assemble) 2.Assemble according to step 337 of the manual to step 338 Continue to change according to the following figure:...
Page 62
Refer to step 344 of the manual to complete the joint action of the steering wheel...
Page 64
Continue to assemble the whole vehicle according to step 356 of the manual. After that, put the lithium battery in the trunk of the vehicle. Connect the motor connector and The whole power chassis has been refitted here. It's great. Inject the soul into you car and put it together.
Need help?
Do you have a question about the Lamborghin Sian FKP 37 and is the answer not in the manual?
Questions and answers