Advertisement
Quick Links
Advertisement
Summary of Contents for Amplified Nation Wonderland Overdrive v2
- Page 1 Amplified Nation Wonderland Overdrive v2 OWNER’S MANUAL...
- Page 2 You will immediately feel how flexible the amp can be, and so many of the iconic tones are very easy to dial in. The Wonderland Overdrive v2 comes in different power levels, from 22w to 100w and can be found in head or combo form factor. The higher wattage have increased headroom as you get higher in wattage;...
- Page 3 DC. Do not attempt to service, repair or conduct tube biasing unless you are qualified to do so. Please contact Amplified Nation beforehand with questions in this regard. Amplified Nation takes no responsibility or shall be held liable for any personal harm caused or damage to this amplifier as a result of unauthorized service, repair or internal adjustments made to this amplifier.
-
Page 4: Front Panel Functions
Front Panel Functions Input Jack: High impedance input to the amplifier. Plug in your instrument here. Treble: Adjusts the high frequency response. In the full counter-clockwise position, high frequencies are bypassed to ground. In the full clockwise position, high frequencies are increased. Middle: Adjusts the mid-range response. - Page 5 Front Panel Functions (CONTINUED) Overdrive Switch: Switches the amplifier channel, sending the instrument signal through the overdrive channel. To enable foot switch control of this function, this switch must be down. PAB Switch: This switch bypasses the tone controls, increasing both level and mids. To enable foot switch control of this function, switch must be down.
-
Page 6: Rear Panel Functions
Footswitch Jack: The footswitch connects with the included 7 pin locking cable. The functions of the Wonderland Overdrive v2 include channel switching and preamp boost. - Page 7 Fuse Chart All Fuses are 3AG Type 250 Volt, SLO-BLO Domestic Fuses: Export 220, 230, 240 Fuses: 2A – 22/35/40 Watt 22/35/40 Watt 3A - 50 Watt 2A - 50 Watt 3.2 - 100 Watt 2.5A - 100 Watt Tube Complement V1- 12AX7, Input and Tone Stack Recovery V2- 12AX7, Overdrive Stages V3- 12AT7, Reverb Driver and Return...
- Page 8 Bias Adjustment Procedure All of our amps are equipped with external bias test points and an external bias adjustment pot. The adjustment pot is located in between the power tube sockets and should be adjusted using an insulated flat tip screwdriver. Power up unit connected to proper speaker load Do not have an instrument connected to the amp Take the amp off of standby and let it stabilize...
- Page 9 It is the customer’s responsibility to pay to ship the product to us, and if it is determined the warranty doesn’t apply, the customer is responsible for the return shipping. If the product is a warranty repair, Amplified Nation will cover the return shipping. CONTACT US This manual is a resource for some of your questions.
Need help?
Do you have a question about the Wonderland Overdrive v2 and is the answer not in the manual?
Questions and answers