PUREGEAR pureboom Manual

Connecting / Bluetooth Pairing

1. Make sure the PureBoom Wireless Speaker is within 2-3 feet (0.6-0.9 meters) of the device you will be connecting to.
2. Turn on your device's Bluetooth. Most devices will automatically detect your speaker. Locate and select "PureBoom". It will indicate that your speaker is now connected or paired.
   If your device does not automatically detect the speaker, make sure Bluetooth is turned on. Locate "PureBoom" then click connect.
   If you're still having trouble, try turning off the speaker then turn it on again. Make sure the speaker is in pairing mode indicated by a flashing blue light.

Operating PureBoom Wireless Speaker

When playing music:

• To skip to the next song, short press the + button once.
• To skip to previous song short press – button once.
• To play/pause, press the play button once.

When on a call:

• To answer or hang up a call, press the play/pause button once.
• To reject a call, press and hold the play/pause button.
• To increase volume, long press the + button to your desired volume.
• To decrease volume, long press the – button.

Features and Specifications

Frequency Response: 20Hz – 15KHz

Charging input: 1A

Li-ion battery size: 1500mAh

Drivers: Ø52/5W

Impedance: 4 ohm

FCC Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

FCC ID: 2AIIF-09290PG

pure-gear.com

©2021 | F00169PG | 09290PG