Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for SmartDHOME 01335-1900-00
Summary of Contents for SmartDHOME 01335-1900-00
- Page 1 Dual mount motion and occupancy sensor User manual Thank you for choosing the dual mount motion and occupancy sensor. Z-Wave certified, the device is compatible with the gateways of the MyVirtuoso Home home automation system. www.myvirtuosohome.com www.smartdhome.com Rev. 1 del 10.11.2022 Pag. 1/9...
-
Page 2: General Safety Rules
Do not use the device in gas saturated environments. Do not place the device near heat sources. Use only the original EcoDHOME accessories supplied by SmartDHOME. Do not place the connection and / or power cables under heavy objects, avoid paths near sharp or abrasive objects, prevent them from being walked on. - Page 3 User manual Disclaimer SmartDHOME Srl cannot guarantee that the information regarding the technical characteristics of the devices in this document are correct. The product and its accessories are subject to constant checks aimed at improving them through careful analysis and research and development activities. We reserve the right to modify components, accessories, technical data sheets and related product documentation at any time, without notice.
-
Page 4: Specification
Dual mount motion and occupancy sensor User manual Specification Power supply 1.5V AA batteries x3 Protocol Z-Wave Frequency 868,4 Mhz Degree of protection IP44 PIR detection coverage: up to 10 m x 110° (at 1.8 m mounting height & 25°C); up to 5 m x 360°... - Page 5 Dual mount motion and occupancy sensor User manual a radius of no more than 1 meter from the MyVirtuoso Home HUB. Assembly The Motion sensor can be mounted either on a wall or on a ceiling. Before selecting a position for Motion sensor, the following points should be noted: 1) Do not position the detector facing a window/fan/air-conditioner or direct sunlight.
-
Page 6: Wall Mounting
Dual mount motion and occupancy sensor User manual 3) Insert 3 AA-size 1.5V alkaline batteries into the battery compartment, ensuring correct polarity is followed (FIGURE 3). FIGURE 3 4) Decide if the detector is to be wall-mounted (FIGURE 4a) or ceiling-mounted (FIGURE 5a), based on the coverage angles shown in FIGURE 4b and FIGURE 5b. -
Page 7: Ceiling Mounting
Dual mount motion and occupancy sensor User manual Ceiling mounting The recommended position for ceiling mounting is at a height of 2.8m (9.19ft) from the floor. At this height, the optimum detection range is up to 5m (16.41ft) with coverage range of 360 degrees (FIGURE 5b). Settings Coverage range adjustments Two types of lens cover are provided for the detector. -
Page 8: Troubleshooting
Dual mount motion and occupancy sensor User manual Simply turn the cover anticlockwise to remove the wall-lens cover from the detector (FIGURE 6e). FIGURE 6E Once the wall-lens cover is removed, re-fit the detector with ceiling-lens cover and turn it clockwise, ensure the mark on the cover is pointing towards and aligned with the mark on the detector (FIGURE 6f). - Page 9 After a short registration you can open a ticket online, also attaching images. One of our technicians will answer you as soon as possible. SmartDHOME Srl V.le Longarone 35, 20058 Zibido San Giacomo (MI) Product code: 01335-1900-00 info@smartdhome.com Rev. 1 del 10.11.2022 Pag. 9/9...
Need help?
Do you have a question about the 01335-1900-00 and is the answer not in the manual?
Questions and answers