LAMAX Dots2 - Wireless Headphones Manual

Controls

Switching On

The earphones turn on automatically when removed from the charging station. To switch on manually, press and hold the multifunction button for 3 seconds. You must manually turn on both earphones separately. When switched on, there is an audible sound and the white LED flashes.

Switching Off

The earphones turn off automatically when inserted into the charging station. To turn off manually, hold the multifunction button on one of the earphones for 3 seconds. When switched off, an audible notification sounds and the red LED flashes. Pairing

1. Remove the earphones from the charging station. The earphones will automatically connect to each other and an audible notification will sound. The left earphone is the main one, and ready for pairing is indicated by alternating blinking of white and red LEDs.
2. Turn on Bluetooth on your device and look for LAMAX Dots2 in the list of available Bluetooth devices. After successful pairing you will hear an audible notification.

For pairing problems, remove the earphones from the paired devices list on your phone. Turn off the earphones manually and hold the multifunction button for 5 seconds until both earphones blink alternately red and white, then insert them into the charging station and pair as described in 1.

Charging

To charge the charging station, connect the cable to the USB-C port on the back and the end of the cable into a USB power supply with a maximum voltage of 5V. When charging, the LEDS will light up gradually according to the charge status. When fully charged, all 4 LEDs will be lit.

You can also charge the charging station with a Qi-compatible wireless charger.

To charge the earphones, insert them into a charged charging station. The LED light in the headphones flashes twice and then turns red during charging. When fully charged, it goes out.

Parameters

Subject to printing errors.