New one TW80 - Earbuds Manual

Please read the instruction carefully before operating the unit.

LOCATION OF CONTROLS

1. Charging case
2. Indicators of earbuds
3. Multifunction button
4. Ear caps
5. Micro USB jack for charging
6. Earbuds
7. Indicator of charging case

POWER SUPPLY

The unit is powered by a built-in Lithium-ion polymer rechargeable battery. Charge the built-in battery for at least four hours before using the device for the first time.

To charge the internal battery of charging case, connect the smaller end of the supplied USB cable to the Micro USB jack and the other end to a powered USB jack on your computer or an AC power supply (not included). The charging indicator of charging case will blink blue during charging and blue light will stay on when the battery becomes fully charged.

To charge the earbuds, insert the earbuds into charging case and close the top lid, battery charge automatically. The indicator lights on red and turns off when earbuds full charged.

• While using the built-in battery, the environmental temperature should be 5°C (41°F) to 35°C (95°F).
• The built-in battery in this device may present a risk of fire or chemical burn if mistreated. Do not disassemble, heat above 100°C (212°F), or incinerate.
• To get the longest service life of the built-in battery, charge at indoor-temperature.
• Attention should be drawn to the environmental aspects of battery disposal.
• Do not throw batteries in fire!
• Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
• When earbuds low battery, the indicator will flash red with an indication voice. The unit will turn off automatically when the battery is too low to work.
• When charging case is low battery, the indicator will flash BLUE at intervals; If the charging box is completely no battery, bule indication will all go out.

TURNING ON THE EARBUDS

Long press the multifunction button about 5 second until you hear "POWER ON" indication voice then the earbud is power on.

When the earbuds is on the charging case

Open the top lid of charging case, remove the earbuds from the charging case, then the earbuds turn on automatically and the indicators flash blue. When you remove only one unit from the charging case, only the moved unit turns on.

When the earbud is NOT on the charging case

Place the earbud to the charging case and then removed it from the charging case again, then the earbuds turns on automatically.

TURNING OFF THE EARBUDS

Long press the multifunction button about 5 seconds until you hear "POWER OFF" indication voice then the earbud is power off.

When the earbuds is on the charging case

When the earbuds is placed into the charging case, the earbuds will turn off automatically. When the remaining battery charge of the charging case is sufficient, earbuds RED indicator will light up and it will start charging of the earbuds.

When the earbud is NOT on the charging case

If the earbuds taken out from the charging case about 5 minutes but it still not yet wear to your ears, then earbuds will turn off automatically.

To turn off the power before the earbuds turns off automatically, please place the earbuds into the charging case.

INSERT THE EARBUDS INTO YOUR EARS

Put the unit with marking L (left) on your left ear and the unit with marking R (right) on your right ear, you will hear the indication voice "left channel" and "right channel" once earbuds wear to your both ears.

If only one of the earbud wear to your ear, you will hear "pairing" (or "connected") indication voice.

How to wear the earcaps

The unit is equipped with large & small size ear caps as accessories. Choose and place right ear caps on the earbuds as below. Then wear each earbuds to your both ears.

BLUETOOTH FUNCTION

The Bluetooth^® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by New One S.A.S is under license. Other trademarks and trade names are those of their respective owners.

Pairing a Bluetooth Device

1. Open the top lid of charging case, remove the earbuds from the charging case, then the earbuds turn on automatically, put the earbuds on your ears, once your hear "Pairing" indication voice that it is in paring mode, the indication will blink Red and Blue alternately.
2. On the Bluetooth device, enable Bluetooth and select "TW80" from the Device List.(Refer to the user manual of the device to be connected for detailed operations.) If the Bluetooth device prompts for a pass code, use "0000". Some Bluetooth devices will ask you to accept the connection. If the unit is paired properly, you will hear the indication voice "Connected", the indicator will stop blinking. If there is no pairing or pairing is not successful within 5 minutes, the earbuds will turn off automatically.

• On some devices such as computers, once paired you must select the unit from the Bluetooth menu and choose "Use as Audio Device (stereo)" or similar.
• Pairing remains intact when the unit and/or your Bluetooth device is taken out of communication range. An active connection will be re-established when your Bluetooth device returns within range.
• When the unit is turned on again, it will automatically try to reconnect with the most recently paired Bluetooth device.

Using a Bluetooth Device

1. With a unit paired (see previous section), operate your Bluetooth device and its sound will be heard through the earbuds.
2. Press the multifunction button once to pause playback. Press again to resume playback.
3. Double click the multifunction button quickly on your left earbud to increase the volume, Double click the multifunction button quickly on your right earbud to reduce the volume. You can also adjust the volume on the device you are paired with.
4. Triple-click the multifunction button quickly on your left earbud to skip the next track, and triple-click the multifunction button quickly on you right earbud to skip the previous track.
5. Long and hold the multifunction button about 3 seconds to enter into voice assistant mode. (Note: this function is only available for "ios" system)

Receiving a Phone Call

This unit is equipped with a built-in microphone, which allows you to make or end calls of a connected mobile phone through this unit. Make sure your Bluetooth-enabled mobile phone is paired with the unit. When there is an incoming call to the connected mobile phone, you will hear an incoming call alert tone from the unit.

1. Press the multifunction button once to answer the incoming call, press again to end call.
2. To reject the incoming call, press the multifunction button twice of the earbuds.

To prevent possible hearing damage, do not listen at high volume levels for long periods.

Maximum output voltage ≤ 150mV

Wide Band Characteristic Voltage ≥ 75mV

TROUBLESHOOTING GUIDE

Should this unit exhibit a problem, check the following before seeking service:

No Power

• Power is not on; turn on the unit again.
• Make sure the battery is recharged.

No Sound – General

• External device' s volume is set to minimum; raise volume.
• The TW80' s volume is set to minimum; raise volume.

The Bluetooth device cannot pair or connect with the unit

• You have not activated the Bluetooth function of your device. Refer to the user manual of your device to activate Bluetooth function.
• The unit is already connected with another Bluetooth device; disconnect that device and then try again.

The earbuds cannot pair with each other

• When the indicator of earbud blinks white and red simultaneously or light doesn't work, indicating it's connect failure. In this case, please put both earbuds into charging case correctly and close the top lid to turn off the earbuds. When you turn them on again, they will connect each other automatically.

SPECIFICATIONS

RECHARGEABLE BATTERY

Earbuds Battery Type: 3.7V 50mAh Lithium-ion polymer Battery

Charging Case Battery Type: 3.7V 300mAh Lithium-ion polymer Battery

Charging Power: DC 5V 500mA

Operating Time: Approx 2 hours after fully charged

Charging Time: Approx.1 hours

BLUETOOTH

Bluetooth: 2.402 - 2.480GHz

RF Output Power: +2 dBm

Bluetooth Version: V5.0

Working Distance: Up to 10 meters measured in open space (wall and structures may affect range of device)

Specifications are subject to change without notice.

• No naked flame sources, such as lighted candles, should be placed on the apparatus.
• The use of apparatus in moderate climates.
• The apparatus should not be exposed to dripping or splashing.
• Ensure a minimum distance of 5cm around the apparatus for sufficient ventilation.
• Do not place objects filled with liquids, such as vases, on the apparatus.
• Under the influence of electrical fast transient or/and electrostatic phenomenon, the product may malfunction and require user to power reset.
• Excessive sound pressure from earphones and headphones can cause hearing loss.

If at any time in the future you should need to dispose of this product please note that Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice.(Waste Electrical and Electronic Equipment Directive)

Hereby, NEW ONE S.A.S, declares that this NEW ONE TW80 is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The declaration of conformity may be consulted at www.new-one.eu

NEW ONE S.A.S
10, Rue de la Mission, 25480 Ecole Valentin, France