VS Sassoon Smooth & Wave VSP2662A Manual

Congratulations on the purchase of your new VS Sassoon Smooth & Wave. The clever 2 in 1 tool that quickly and effortlessly creates beautiful, soft lasting waves as well as smooth, straight styles all with the flick of a switch. A revolution in automatic styling technology!

STYLING INSTRUCTIONS

As the Smooth & Wave is a revolutionary new type of styler, it works very differently to the styling tools you may have used in the past. As such it's important to carefully read through the instructions before using for the first time.

BEFORE USE

• When using the unit for the first time, you might notice a little smoke and distinct odour: this is common and will disappear by next use.
• Each time you use the appliance, you may see some steam. Do not be concerned, this could be because of the evaporation of the natural oils of the hair, residual hair products, or excess moisture evaporating from you hair.

INSTRUCTIONS FOR USE

CREATING WAVES

1. The hair should be clean, dry, combed through and free of dry shampoo, hairspray, mousse, spray wax, styling dust and all other styling products. Comb through to remove any tangles and divide the hair into sections, no bigger than 3cm wide.
   
2. Select the wave setting by sliding the switch to wave mode .
3. Wave direction can be selected by sliding the switch to desired direction:
   = Clockwise
   = Alternate
   = Anti-Clockwise
4. Always insert the styler into the hair with the open part of the ceramic chamber facing towards the head.
   
5. 
   The neat section of hair must be inserted into the opening, beyond the hair stopper (A) until it reaches guide (B).
   
6. 
   Firmly close the handles together to allow the hair to be drawn into the ceramic chamber.
   Keep the appliance in position and once the hair has been drawn into the ceramic chamber, the appliance will start beeping. Continue to hold the handles closed until the appliance sounds finish audio, this is to indicate the time is up.
7. Release the handles fully and gently move the styler away from the head to reveal the wave.
   

CREATING SMOOTH STYLES

1. The hair should be clean, dry, combed through and free of dry shampoo, hairspray, mousse, spray wax, styling dust and all other styling products. Comb through to remove any tangles and divide the hair into sections, no bigger than 3cm wide.
   
2. Select the straight setting by sliding the switch to straight mode .
3. Separate a clean section of hair, no bigger than 3cm wide. When working with naturally curly or longer length hair, use smaller sections.
4. Always insert the hair into the appliance with the plate part facing towards the head. Place a section of hair between the straightening plates, close to the roots.
   
5. 
   The neat section of hair must be inserted into the opening, beyond the hair stopper (A) until it reaches guide (B).
   
6. Firmly close the handles together to allow the hair to start to be drawn into the ceramic chamber.
7. As soon as the hair starts to be drawn into the ceramic chamber, holding the hair firmly between the straightening plates, immediately slide the appliance down the length of the hair from root to tip to release the smooth section of hair.
   
8. 
   Do not wait for the hair to be completely drawn into the chamber before straightening. Simply clamp and go to straighten.

HEAT SETTINGS

If you have delicate, fine or coloured hair, use the lower heat settings.

For thicker hair, use the higher heat settings.

It is suggested to always complete a test on initial use to ensure the correct temperature is used on the hair type. Start on the lowest setting and increase the temperature until desired result is achieved.

Below is a guide of the temperature settings:

= OFF
• = 180°C
• • = 200°C
• • • = 230°C

Wave or Straight Settings

The wave or straight setting allows you to switch between the Wave Mode for perfectly formed waves or straight mode for a sleek finish. Below is a guide of the wave and smooth settings:

= Wave Mode
= Straight Mode

Wave Direction Settings

The wave direction settings allow you to chose the direction of your wave formation. Below is a guide of the wave direction settings:

= Clockwise
= Alternate
= Anti-Clockwise

Sleep Mode

This appliance has an automatic sleep mode feature. If the appliance is not used for more than 20 minutes the temperature will automatically drop to 150°C. If you wish to continue using the appliance after this time, simply close then release the handles and it will return to the temperature setting you were using it on.

Auto Shut Off

This appliance has an automatic shut off feature for added safety. If the appliance is switched on for more than 60 minutes continuously, it will automatically switch off. If you wish to continue using the appliance after this time, simply slide the switch to the '' '' setting, then slide the switch to the relevant setting to turn the power on again.

Heat Mat

The appliance comes with a heat mat for use during and after styling.

During use do not place the appliance on any heat sensitive surface, even when using the heat mat provided. After use, switch off and unplug the appliance. Immediately wrap the appliance in the heat mat provided and allow to fully cool down. Continue to keep it out of reach of children as it will remain hot for several minutes.

FEATURES

1. Ceramic Curl Chamber
2. Floating Ceramic Straightening Plate
3. 3 Temperature Settings (180°C, 200°C, 230°C)
4. Rotation Selector (LEFT, RIGHT OR ALTERNATE)
5. Straight or Wave Setting Selector
6. 2.5m Swivel Cord

SAVE THESE INSTRUCTIONS AND WARRANTY

Vidal Sassoon and related logos are trademarks of The Procter & Gamble Company used under license by Conair
©2017 Conair Australia Pty Ltd
Suite 101, 18 Rodborough Rd
Frenchs Forest NSW, 2086
Australia

CUSTOMER SERVICE:
Australia: 1800 650 263
New Zealand: 0800 266 247

CONTACT US:
For advice, tips on your new VS product
E-mail us on: aus_info@conair.com

VSP2662A