Advertisement
Charging
The LED indicator will flash red if the battery level is low, which
indicates charging is necessary.
1. Plug the USB end of the charging cable to a USB charging port or
any active USB port (charging power: DC 5V).Connect the Micro
USB end of the charging cable to the charging port of the WISEQ 019
2.
The LED indicator will turn red when charging.
3.
The LED indicator will automatically turn off when the device is
fully charged. It takes up to 3 hours to fully charge the Bluetooth
adapter.
Note:
a.
Poor quality power adapters do not provide a stable current ,
which may generate current noises when using.
b.
To avoid battery over-discharge, please recharge the device once
a month if the device is not in regular use. Lithium-Ion batteries
continue to slowly discharge (self-discharge) when not in use or
while in storage.
Common Functions
1. Power On/Off
Press and hold the Multifunction Button for 3 seconds.
Power on: the LED light is bright
Power off: the LED red and blue lights turn on and flash two times,
and then go out
2. Automatically Pairing with Previously Paired Devices
WISEQ 019
the first time.
and will attempt to pair with devices automatically, without going into
pairing mode.
3. Quickly Enter Pairing Mode
Quickly double-click the Multifunction Bu tton to enter
pairing mode after the
4. TX/RX Mode Switch
TX/RX mode can only be successfully switched after the adapter is
turned off for 5 seconds.
Note: turn of f the
mode switch is not functioning properly.
will enter pairing mode automatically when powered on for
WISEQ 019
can
WISEQ 019
WISEQ 019
remember previously paired devices
is powered on.
and restart it after 5 seconds if the
2
Advertisement
