Operation Instructions; Setting Up Your Ct320 Planer; Prior To Operation; Changing Or Installing Tooling - Bartell Global CONTEC CT320 Owner's Manual And Parts Book

Floor planer/scarifier

Hide thumbs

Table Of Contents

Table of Contents

CT320 FLOOR PLANER/SCARIFIER

OWNER'S MANUAL AND PARTS BOOK

SETTING UP YOUR CT320 PLANER

Your CT320 Floor Planer comes fully assembled with handle and motor fully installed.

The tooling drum may also be installed from factory, if drum is not installed please see the

installation instructions below.

PRIOR TO OPERATION

• Make sure that all dust, debris etc., are thoroughly removed from the unit prior to

operation. Special effort should be given to the bottom of the machine where the tooling

drum is located.

• Check all bolts and screws for tightness and make sure all bolts and screws are securely

tightened. Loose bolts and screws may cause damage to the unit. Make sure tooling is

properly installed.

• The height adjustment lever must be in the upper position before machine can be

switched on

• Before switching the machine on turn the height adjustment hand wheel counter-

clockwise as far as possible

CHANGING OR INSTALLING TOOLING

• Lift the machine with the lever so that the tools are well clear of the floor.

• Remove the M10 screws on the right side of the plate. Carefully remove the side plate

• Take out the drum. Remove worn out tools. Check the drum for wear and tear. If

necessary, replace new tools on the drum.

• Before reinstalling drum, grease the shaft, then reinstall drum.

• Put the side plate back on and use the screws to mount it.

ATTENTION: Before working on the Planer bring the motor to a total stand still and

disconnect from the power supply.

CAUTION: Tools can be hot after use.

ADJUSTING THE DRUM ALIGNMENT

During operation the drum shaft and rear wheel axis may fall out of alignment. This results in an

uneven track on the floor. One side touches the floor before the other side and therefore

resulting in an uneven surface. Follow instructions below to align the drum

• Place the planer on an even floor. Lift the tools off the floor using the hand wheel.

• Loosen the clamping screw of the eccentric shaft of the rear wheels.

• On the other side of the rear wheel is a screw which keeps the wheel on the shaft.

Turning the screw will also turn the eccentric shaft. The floor planer moves up and down

on one side.

• Keep turning the screw, clockwise, until all the tools on the drum are an equal distance

from the floor. Caution: Turning the screw counter- clockwise will loosen the screw.