Advertisement
Quick Links
Advertisement
Related Manuals for Schiit VIDAR 2
Summary of Contents for Schiit VIDAR 2
- Page 1 0222V00000 115VAC/75 T H E F U L LY M O D E R N O L D S K O O L P O W E R A M P...
- Page 2 If you have some common sense, they as-heck power amplifier. But at the same should seem pretty straightforward. In any case, read these time, Vidar 2 has an eye to the future, instructions before proceeding farther, follow all instructions, with full microprocessor management and heed all warnings.
- Page 3 0222V00000 115VAC/750W 1 Connect both left and right speakers. 3 Get powered up. Connect to a wall Connect your right speaker to the right socket with the provided AC cord. Or red and black output terminals and your you can use any IEC-type cord; ours isn’t left speaker to the left red and black special.
- Page 4 0222V00000 115VAC/750W 1 Connect your speaker to the two top 4 Get powered up. Connect to a wall red terminals only. Right is “+”, and left is socket with the provided AC cord. Or use “-”. Please note both of these are active any IEC-type cord;...
- Page 5 Standby when you’re not using it *Vidar 2 takes about 30 seconds to perform self- checks when first turned on. When coming out of 2 When lit, this light indicates Standby Standby mode, it takes about 60 seconds.
- Page 6 To troubleshoot this, turn off the amp, discon- When the Vidar 2’s front light flashes during nect the speaker cables from the amp, and operation (and the amp mutes), or if it never turn it back on again.
- Page 7 Schiit Audio warrants to the original purchaser that this product shall be free from defects in material and workmanship for five (5) years from the date of purchase. If a defect covered by this warranty occurs during this period, Schiit Audio will repair the defective product, free of charge.
- Page 8 (1) Power Cord (0) Class D modules (0) Switching supplies (Various) Stickers and stuff (Infinite) Appreciation from the whole Schiit crew in Valencia, CA and Corpus Christi, TX (Even more) Thanks from our chassis and PCB guys in California, Nevada, and Utah.
Need help?
Do you have a question about the VIDAR 2 and is the answer not in the manual?
Questions and answers