4M UNICORN FOUNTAIN Manual

13. Pour some water into the water container.
14. Switch on the fountain. Water will magically run out through the water tray, your unicorn fountain is complete.
E. HOW DOES IT WORK?
The batteries operate the motor inside the motor module, which turns a small water pump. This pumps water from the water container
into the transparent tube leading to the tap. The water comes out of the tap and pours back into the water container. The water circulates
continuously.
F. TROUBLESHOOTING
If the water does not flow:
• Check that the batteries are fresh and inserted the correct way round in the battery compartment.
• Check that you have connected the wires between the motor and battery correctly.
• Check that there is enough water in the water container.
Air may get trapped inside the tube and disrupt the flow of water:
• Remove the trapped air by quickly turning the tap on and off a few times.
• Alternatively you can pour water inside the transparent tube by removing the tap head temporarily.
• Avoid spilling water into the battery case and motor cabinet. If this does happen, unscrew all the covers and let everything dry out. (Blow
it with a hairdryer to dry it more quickly.)
G. FUN FACTS
• The water pump inside the Unicorn Fountain has a tiny fan-shaped blade called an impeller. When the impeller spins it pushes water
into the pipe that leads to the top.
• Water comes out from the top because of a force called water pressure. The pump in the Unicorn Fountain creates water pressure that
pushes the water into the pipe leading to the top.
• About one in five people in the world live without access to clean water at home.
• In total, women in Africa spend 40 billion hours every year walking to fetch clean water.
• A clean water supply to all homes could save up to a million lives every year.
• Global warming means that droughts are likely to be more common and more severe.
• Many charities around the world are working to bring clean water to everyone.
• Water fountains, fish tanks and swimming pools all have pumps that circulate just like the pump in the Unicorn Fountain.
QUESTION AND COMMENTS
We treasure you as a customer and your satisfaction with this product is important to us. In case you have any comments or questions, or you find any
parts of this kit missing or defective, please do not hesitate to contact our distributor in your country, whose address is printed on the package. You are
also welcome to contact our marketing support team at Email: infodesk@4M-IND.com, Fax (852) 25911566, Tel (852) 28936241, Web site: WWW.4M-
IND.COM
©2022 4M INDUSTRIAL DEVELOPMENT LIMITED. ALL RIGHTS RESERVED.
UNICORN
PLEASE SCAN THE QR CODE TO VIEW MULTI-LANGUAGE INSTRUCTIONS
FOUNTAIN
A. SAFETY MESSAGES
1. Please read through all the instructions and keep them since they contain important information. 2. Adult assistance and supervision
are required. 3. This kit is intended for children 5 years or older. 4. This kit and its finished product contain small parts which may cause
choking if misused. Keep away from children under 3 years old. 5. To prevent possible short circuits, never touch the contacts inside the
battery case with any metal. 6. Only install batteries after the kit is assembled. Adult supervision is required.
B. USE OF BATTERIES
1. Requires two 1.5 V AAA batteries (not included). 2. For best results, always use fresh batteries. 3. Make sure you insert the batteries
with the correct polarity. 4. Remove the batteries from the kit when not in use. 5. Replace exhausted batteries straight away to avoid
possible damage to the kit. 6. Rechargeable batteries must be removed from the kit before recharging. 7. Rechargeable batteries must be
recharged under adult supervision. 8. Make sure the supply terminals in the battery case are not short circuited. 9. Do not attempt to
recharge non-rechargeable batteries. 10. Do not mix old and new batteries. 11. Do not mix alkaline, standard (carbon-zinc), or
rechargeable batteries. 12. Unscrew the battery case cover to replace battery. Adult supervision is required.
C. CONTENTS
Part A: water container, Part B: water tray, Part C: motor module, Part D: blade cover, Part E: container cover, Part F: wire cover, Part G:
T tube, Part H: castle base, Part I: disk, Part J: unicorn figurine, Part K: transparent tube, Part L: unicorn figurine holder, Part M: battery
cover, Part N: sticker, Part O: castle roofs x 2, Part P: terminal caps x 2, Part Q: flowers x 4, Part R: screws x 10. Also required, but not
included in this kit: 2 x 1.5V AAA batteries, a small crosshead screwdriver.
WARNING:
CHOKING HAZARD - Small parts.
Not for children under 3 years.