Table of Contents
Advertisement
en operation
Making ice cubes
Use only drinking water to make ice
cubes.
Fill the ice cube tray with drinking
1.
water up to ¾ and place in the
freezer compartment.
If the ice cube tray is stuck to the
freezer compartment, loosen it with
a blunt implement only (e.g. spoon
handle).
To loosen the ice cubes, twist the
2.
ice cube tray slightly or hold it
briefly under flowing water.
operation
7 Basic operation
operation
7.1 Switching on the appli-
ance
Electrically connect the appliance.
1.
→ Page 11
a The appliance begins to cool.
a A warning signal sounds, the tem-
perature display (freezer compart-
ment) flashes and
because the freezer compartment
is still too warm.
Switch off the warning tone using
2.
.
goes out as soon as the set
a
temperature has been reached.
Set the required temperature.
3.
→ Page 16
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
16
¡ The front and side panels of
¡ When you close the door, a va-
7.3 Switching off the appli-
▶
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
▶
lights up
Setting the freezer compartment
temperature
▶
the housing heat up occasionally.
This prevents condensation from
forming.
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
ance
Disconnect the appliance from the
power supply. Unplug the appli-
ance from the mains or switch off
the circuit breaker in the fuse box.
Press
repeatedly until the
temperature display (refrigerator
compartment) shows the required
temperature.
The recommended temperature in
the refrigerator compartment is
4 °C.
Press
repeatedly until the
temperature display (freezer com-
partment) shows the required tem-
perature.
The recommended temperature in
the freezer compartment is
−18 °C.
Advertisement
Table of Contents
