Vacuum Compartment; Auto Drawer - Hitachi R-ZX740KN Instruction Manual

Vacuum Compartment

1
Pull out the Vacuum Case.
For how to remove,
Be sure to remove foods contained in the Vacuum Case.
2
Wipe off following parts with a soft
cloth which is steeped in lukewarm
water.
※ Do not use the detergents, etc.
Aluminum Tray
Vacuum compartment gasket
Request
● Wipe the ceiling of the compartment (platinum catalyst
and LED light) gently. Failing to do so may cause damage.
● If detergents and others except lukewarm water are used
to clean the vacuum compartment gasket, the vacuum
compartment gasket may be damaged, deformed or
change in color, which may cause the vacuum state
unable to keep well.
3
Attach the Vacuum Case.
For how to attach,
Loosened vacuum compartment gasket or loose-fitting door of the
Vacuum Case may cause the vacuum state unable to keep well.

Auto Drawer

Clean the auto door unit when food falls onto or is caught in the upper part of the auto door unit and when liquid is deposited on the auto door unit.
1
Unplug the power plug.
2
Remove each case of the Lower Freezer or the
Vegetable Compartment.
3
Remove all foods which drop or are caught in.
4
Wipe off deposited liquid using a soft and dry cloth.
Caution
● Make sure that water never splash to the Auto Drawer unit. Otherwise, it may cause malfunction.
● Do not disassemble the Auto Drawer unit. Otherwise, it may cause injury and/or malfunction.
● Exercise caution not to move the linkage section. Failing to do so may cause a failure.
Once a month
Pg.70
Vacuum Compartment
Vacuum Container Gasket seat
Pg.70
Pg.71
When the Vacuum Compartment Gasket is dirt
1
Remove the vacuum compartment
gasket from the Vacuum Case.
Grasp the tab of the vacuum
compartment gasket on the
observer's upper right and
remove it by hand
carefully.
2
Rinse dirty portion in water using
a soft sponge, etc.
※ Do not use the detergents, etc.
3
Wipe off excess moisture with a
dry cloth and dry it out naturally.
4
Wipe off dirt in the vacuum
compartment gasket
mounting groove.
Groove for attaching the vacuum compartment gasket.
5
Attach the vacuum compartment gasket.
Align the vacuum compartment gasket tab with the notch of
the mounting groove.
R-ZX740K type
Align the indentations of the
gasket with the projection
(6 locations) of the case and
attach firmly.
R-WX670K type
R-WX620K type
Align the hollows of the
gasket between the
projections (6 locations) of
the case and attach firmly.
● Make sure to disconnect the power plug from
the power outlet before starting maintenance to
avoid injury.
Tab
Tab
Notching of the mounting groove
Locations of the projections of the case
Projection of the case Projection of the case
Fins
R-ZX740K type R-WX670K type
R-WX620K type
Hollows in the gasket
Warning
Linkage section
Auto Drawer Unit
67