Summary of Contents for Aqua Design Omnia
- Page 1 Omnia Hand Dryer Installation Instructions AquaDesign Mfg +1 800-999-3101 1748 W. Fillmore St. www.AquaDesignMfg.com Phoenix, AZ 85007 info@AquaDesign<fg.com...
- Page 2 • (C) Firmly screw the base of the device to the wall, ensuring that the 4 silent- blocks are correctly • The on-center distance to the Omnia water faucet should be at 5-1/2” placed between the base and the wall.
- Page 3 Product Manual Omnia Hand Dryer Product Manual Omnia Hand Dryer IR SENSOR CONNECTION • (A) Route the wire through the plastic support (14) and connect according to B & C. • (B) Connect the IR sensor wire to the electronic board.
- Page 4 Product Manual Omnia Hand Dryer Product Manual Omnia Hand Dryer Carry out this operation taking maximum care not to damage any component of the electronic circuit. ADJUSTMENTS • Clean the casing using a damp cloth moistened in a solution of neutral soap and water. After cleaning the entire surface, to rinse the soap from the casing using another cloth moistened in water and dry using a dry cloth.
Need help?
Do you have a question about the Omnia and is the answer not in the manual?
Questions and answers