Mounting options
1
Parts list
M
H
I
D
F
C
Depending on the applied waste drain plug you will need to use part
EN
Afhankelijk van de gebruikte wastafelkrepien zult u onderdeel
NL
Selon le model du crepine, vous devrez utiliser la piece
FR
Nach dem modell der Abflussventil müssen Sie Teil
DE
Disclaimer
If you install the product in a way that differs from this manual, this will void all guarantees. Before installation check that the product meets all your requirements and is
not damaged. By proceeding with installation, you accept the condition of the product.
Disclaimer
Indien u het product plaatst op een manier die afwijkt van deze handleiding, vervalt alle garantie. Controleer voor plaatsing of het product aan al uw eisen voldoet en niet
beschadigd is. Indien u overgaat tot plaatsing, aanvaardt u de staat waarin het product zich bevindt.
Clause de non-responsabilité :
Si vous installez le produit d'une manière différente de celle présentée dans ce manuel, toutes les garanties seront invalidées. Contrôlez avant le placement si le produit
répond à toutes vos exigences et n'est pas endommagé. En procédant au placement, vous acceptez l'état dans lequel se trouve le produit.
Haftungsausschluss
Wenn Sie das Produkt nicht genau nach den Angaben in dieser Montageanleitung einbauen, verfällt die Garantie. Überprüfen Sie vor dem Einbau des Produkts, ob sämtliche
Voraussetzungen erfüllt sind und das Produkt nicht beschädigt ist. Sobald Sie mit der Montage beginnen, sehen Sie, in welchem Zustand sich das Produkt befindet.
!
K
G
OR
(see remark below)
J
L
x 3
x 2
E
D
x 2
C
A
B
Santeg Styledrain UN/UP-X 5/4"- 32 mm
2
Technical drawing
G1
/
1
4
Ø80
G
or K.
G
of
K
dienen te monteren.
G
ou K.
G
oder
K
verwenden.
Installationguide
Installatiegids
Guide d'installation
Montageanleitung
350
78,5
68653_INSTALL_INT_ver2019.1.3
Need help?
Do you have a question about the Styledrain UN/UP-X 5/4 and is the answer not in the manual?
Questions and answers
The nut came of the lid while I was cleaning it. And now I want to disassemble the drain in order to collect the nut again, but I can not find how to disassemble the drain.