Outdoor Furniture Plus Woodhaven 1/4 Assembly Instructions

1/4 and 1/4 Plus Woodhaven
All Woodhaven Firewood Racks are proudly Made in the USA!

ASSEMBLY:

To assemble, bolt the horizontal bottom tube (B) on the inside of the
welded end section (A)-see inset. Slide the bolts through from the
outside of the rack to give a nice, clean look. The nuts have a nylon
insert to prevent them from working loose. The threaded side of the
nut goes on first and will require (2) 7/16" wrenches to tighten. Do
not over tighten.

COVER:

Woodhaven was the first to design covers to cover firewood the way it
needs to be! It keeps the top dry and ready to burn, and allows for air
to flow through the firewood to reduce mold and mildew and promote
curing. Our standard cover fits around the 4 uprights of the rack
and moves down as the wood stack is used. Sewn-in wind straps may
be used for windy conditions.
Full Covers are available at www.firewoodracks.com

IMPORTANT PLACEMENT:

To prevent the possibility of this product tipping over, it MUST be placed on a hard, level surface such as concrete or
heavy concrete stepping stones for each foot. NEVER PLACE T HI S RACK ON DI RT OR ANY OTHER UNSTABLE
SURFACE.

FIREWOOD:

To find a firewood dealer in your area or to find more information about proper burning techniques and firewood information p lease visit
www.firewoodcenter.com.

FEEDBACK:

We value your feedback. Visit us at www.firewoodracks.com/contact.html to leave any comments, suggestions or testimonials.
Firewood Rack Assembly Instructions
®
A
B
B
A