Do you have a question about the A 1011 and is the answer not in the manual?
Questions and answers
Summary of Contents for Altronic A 1011
Page 1
Model: A 1011 Two Channel UHF Remote Control Switch System Operating Instructions This 433MHz rolling code remote control switching system allows you to switch connected devices on and off remotely. It could be integrated with fans, LED lighting, cameras, doors, locks, motors and much more! Package includes two dual button remote trans- mitters and waterproof outdoor receiver unit.
Page 2
Learning Mode: Programming: NOTE: The radio control units included in the pack are already programmed and ready to use. See the above diagram to nd the correct buttons to press. Press the P1 as instructed below to enter different modes: ONE time to program R1 in monostable mode - LED ashes one time and stays alight, then press the button that you want the unit to learn, until the LED goes off.
Page 3
Erasing Codes There are two types of code deletion available. Deletion of an Individual Programmed Code: Press the P2 key for approximately 2 seconds then let go, the LED will come on. Press the key on the radio control unit to be deleted. Deletion of ALL Programmed Codes: Press P2 until the LED comes on, approximately 8 seconds.
Page 4
Altronic Distributors warrants this product for one year from date of purchase from Altronics or its resellers to the consumer. If this item is part of an installation or another product, please contact the installer or supplier for your warranty.
Need help?
Do you have a question about the A 1011 and is the answer not in the manual?
Questions and answers