Summary of Contents for KC 100.124
- Page 1 Benthic Chamber Model 100.124 Manual Denmark A/S Research Equipment Limnology Oceanography Hydrobiology ⚫ ⚫...
- Page 2 Benthic Chamber KC Denmark A/S is not, and cannot be held, responsible for any damage(s) made to equipment or to operators who ignore safety precautions or because of misuse or wrong operation. The below shown devices are very dangerous and may cause serious injury to people. Once loaded, the two burn wire systems “1”...
- Page 3 6. 2 pistons, mounted on the shovel, see next item Two hydraulic pistons for the shovel. The power station contains a very strong spring-loaded mechanism and do not stick fingers or any parts into the holes as a release causes serious injury/damages. 100.124 – Benthic Chamber - Manual...
- Page 4 Attach the U-bracket “2” and push the locking pin “3” through both holes in the bracket. Open the valve “3” in vertical position (shown in horizontal position). 100.124 – Benthic Chamber - Manual...
- Page 5 If the shovel does not move upwards during the pumping, you may push it upwards by hand or better with a wooden stick or similar. Take care to avoid any unattended release, which may cause serious injury. 100.124 – Benthic Chamber - Manual...
- Page 6 Attach the Burn Wire A template for making correct length of the burn wire. Insert a wheel and attach the wire. Make a knot and scrape off the insulation for a distance of 6-8 mm. 100.124 – Benthic Chamber - Manual...
- Page 7 Connect the power cable and the USB cable. Insert the cable into a PC and install the software. Start the software and program the parameters for closing the chamber’s lid and release of the lander itself (if the acoustic releasers fail). 100.124 – Benthic Chamber - Manual...
-
Page 8: Maintenance
USB socket on the battery cylinder. The programmed delay will start with a delay of 1 min. Maintenance The zinc anodes prevent corrosion and you must replace worn out anodes. 100.124 – Benthic Chamber - Manual... - Page 9 100.124 – Benthic Chamber - Manual...
- Page 10 100.124 – Benthic Chamber - Manual...
- Page 11 100.124 – Benthic Chamber - Manual...
- Page 12 100.124 – Benthic Chamber - Manual...
- Page 13 100.124 – Benthic Chamber - Manual...
-
Page 14: Safety Regulations
Safety Regulations KC Denmark A/S is not, and cannot be held, responsible for any damage(s) made to equipment or to operators who ignore safety precautions or because of misuse or wrong operation. Disconnect power supply to avoid any unattended operation causing accident to personnel and winch.
Need help?
Do you have a question about the 100.124 and is the answer not in the manual?
Questions and answers