Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Flexitron Webdyn EasyTunnel
Summary of Contents for Flexitron Webdyn EasyTunnel
- Page 1 EasyTunnel Hardware User Guide www.webdyn.com...
-
Page 2: Table Of Contents
2.4 Packaging ........................12 2.5 Product Label ......................12 2.6 System Architecture ....................13 Caution ..........................21 Mechanical Description ....................26 Device Installation ......................27 SALES CONTACT ....................... 30 contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group... -
Page 3: General Notes
EasyTunnel gateway. Read it carefully before you start working with the EasyTunnel device. The warranty will be void should damage occur due to non-compliance with these instructions for use. We cannot accept any responsibility for consequential loss. contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group... -
Page 4: Revision Information
European Parliament and of the Council of 27 January 2003 (and revised on 8 June 2011) on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS). contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group... -
Page 5: Disposal Of Old Electrical And Electronic Equipment
If you attempt to dismantle the device, you may invalidate the warranty. • The EasyTunnel terminal must not be neither installed nor located in areas where the surface temperature of the metallic case could exceed 85°C. contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group... -
Page 6: Safety Requirements And Protection Regulations
SAR measurement test report and declaration. • You are responsible for observing your country’s safety standards, and where applicable, the relevant wiring rules. contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group... -
Page 7: Sim Card Precautions
Users of the EasyTunnel gateway are responsible for ensuring that they meet the SAR regulatory requirements of the countries in which they intend to operate the device and that their documentation contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group... -
Page 8: Sar Information
If the user’s application is likely to be situated in the vicinity of personnel, a suitable warning should be contained in the equipment manual to this effect. contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group... -
Page 9: Sar Requirements Specific To Portable Mobiles
• RS232 on RJ45 connector. • RS485 on Terminal block connector. • Ethernet configuration port. • Digital input and output. • RTC with Super-Capacitor based backup energy. contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group... - Page 10 Operating temperature (*) -40ºC to +85ºC Storage temperature -40ºC to +85ºC Dimensions with DIN Rail plate 113.2 x 30.5 x 90.2 mm Weight 195g (*) LTE module extended operation contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group...
-
Page 11: Operating Range
2.6 LTE Main antenna 50 ohms LTE Diversity antenna 50 ohms Real Time Clock backup: Internal Supercapacitor 2.3 Ordering Information Model name Part Number EasyTunnel 000199811000 contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group... -
Page 12: Packaging
2.5 Product Label The label fixed to the top of a EasyTunnel device comprises the following information: contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group... -
Page 13: System Architecture
Connectors for external interfaces are grouped to be accessible at a common front and rear panel. contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group... - Page 14 LTE interface covers EMEA region and is CE certified with following frequency bands and data rates: 2.7 External Interfaces on Front and Rear Panel Reset Antenna SIMs LEDs Configuration Port RS232 Port Terminal Block contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group...
- Page 15 • Reset push button (rear panel) 2.8 Terminal Block Connection EasyTunnel device has a terminal block type connector for fastening to front panel for power supply input, RS485 port and inputs connection. contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group...
- Page 16 EasyTunnel is fitted with a 50Ω SMA female coaxial connector. These external antennas must be matched properly to achieve the best performance regarding radiated power, DC-power consumption, modulation accuracy and harmonic suppression. contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group...
- Page 17 70V/m and at 1m it will have reduced to 7V/m. In general, CE-marked products for residential / commercial areas and the light industry can withstand a minimum of 3V/m. contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group...
- Page 18 EasyTunnel presents the possibility of mounting two cards, one as a backup. In the front panel is identified SIM card priority with the numbers 1 and 2. To insert SIM card, look at bellow picture for proper orientation. • Mini Sim 1 contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group...
- Page 19 2.11 Ethernet Configuration Port EasyTunnel gateway provides a basic router-like functionality with ethernet connector (RJ45) available on a RJ45 connector at the front panel with this symbol contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group...
- Page 20 If RS232 cable required length is longer than 3m, it is recommended to use a shielded cable. No hardware related configuration action is needed to enable RS232 port communication. contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group...
-
Page 21: Caution
Data received on this Input is transmitted RS232 Tx to WAN Caution Be careful when connecting pin 1. This voltage is the same that power supply input (+) in terminal block. contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group... - Page 22 If RS485 cable required length is longer than 3m, it is recommended to use a shielded cable. No hardware related configuration action is needed to enable RS485 port communication. contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group...
- Page 23 Fast refers to fast blinking On-Off every 1 second. Slow refers to slow blinking On-Off every 2 seconds. • Power LED: OPERATING STATES STATE Power Off Power Off Boot Failure Fast contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group...
- Page 24 EasyTunnel device integrates Real Time Clock for timestamping purposes. RTC power backup is based on a supercapacitor to allow the system to keep it operating for a time when external power supply is removed. contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group...
- Page 25 3. Wait for modem to restart and ready for operation to check default parameters. Coverage LED start to blink (yellow LED). 4. Release Reset button. 5. Power off the gateway. 6. Power on again. contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group...
-
Page 26: Mechanical Description
Mechanical Description 3.1 Dimensions contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group... -
Page 27: Device Installation
Tip! Before installing the modem, use an ordinary mobile telephone to check a possible location for it. In determining the location for the modem and antenna, you should consider signal strength as well as cable length. contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group... - Page 28 To install device on the DIN Rail, position the top groove of the rear module installation adapter on the top edge of the DIN rail. Push on the arrow direction on the adapter until the bottom groove of the installation adapter fits under the DIN rail. contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group...
- Page 29 This protects the power cabling and gateway. Bellow figure shows connection for all available interfaces, nonetheless, only those required for the end application are to be connected contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group...
-
Page 30: Sales Contact
Av. Coronel Eduardo Galhardo 7-1ºC 1170-105 Lisbon, Portugal Phone: +351.218162625 Email: comercial@lusomatrix.pt APAC 9F, No. 156, Sec. 3, Minsheng E. Rd. Songshan Dist., Taipei City 10596, Taiwan Phone: +886.965333367 Email: contact@webdyn.com contact@webdyn.com | webdyn.com V1.0 subject to changes | Webdyn © by Flexitron Group...