Mounting Bracket Installation; Battery Care - Lowrance 16i Installation Instructions Manual

MOUNTING BRACKET INSTALLATION

1. Attach the gimbal bracket (sold separately) to the base plate with the
nylon nuts and bolts supplied with the power pack.
Hook and loop
battery straps
Secure gimbal bracket to base plate (left) and slide the battery straps
2. Slide the hook and loop battery straps through the slots on either
side of the battery tray as shown in the preceding figure. (The two hook
and loop battery straps pack as one piece that you must peel apart.)

BATTERY CARE

Make sure the battery is fully charged before you use the PPP-16i for
the first time. When fully discharged, it takes approximately nine
hours to recharge the battery. Under ordinary operating conditions, the
battery will run your unit with the backlight on for approximately 24
hours before it needs recharging. Battery capacity will vary depending
on air temperature, water depth, backlight settings and the size of the
sonar or GPS you are using.
To charge the battery, plug the charger into a 110 VAC electrical out-
let, then connect the red lead to the red battery contact and the black
lead to the black battery contact. When you first plug in the charger,
the indicator light glows green, which shows it is receiving power. After
you connect the battery, the light will turn red, indicating the battery
is now being charged. When the light turns green again, the battery is
fully charged.
You can recharge the battery after every fishing trip, even if the bat-
tery was not fully discharged. This will keep the unit ready for your
next fishing expedition. Disconnect the battery when stored for long
periods of time.
Nylon nuts and
bolts for bracket
through the slots on either side of the tray.
Gimbal bracket
Battery
2