Hubbel KILLARK EKJ Series Installation, Operation & Maintenance Data Sheet

EKJ, ECF & EKJSS Flexible Fittings
For Use In Hazardous Locations
English

1. General Safety Information:

CAUTION:
Before installing, make sure you are compliant with area
classifications, failure to do so may result in bodily injury, death
and property damage. Do not attempt installation until you are
familiar with the following procedures. All installation must comply
with the applicable Electrical Code.
Make sure that the circuit is De-energized before starting
installation or maintenance.
Verify that the installation is grounded. Failure to ground will
create electrical shock hazards, which can cause serious injury
and or death.
Important:
Please read these instructions carefully before installing or
maintaining this equipment. Good electrical practices should be
followed at all times and this data should be used as a guide
only.
The Devices are intended for use in hazardous locations where
movement or vibration requires a flexible connection or a difficult
bend is required in a conduit system.
P/N KIL00921480 FORM NO. K1480 ERO-8-049-16 Page 1 of 3
HUBBELL ELECTRICAL PRODUCTS
A Division of HUBBELL INCORPORATED (Delaware)
3940 Martin Luther King Drive
St. Louis, Missouri 63113 USA
INSTALLATION, OPERATION &
MAINTENANCE DATA SHEET
SERIES ECF, EKJ, EKJSS Flexible Fittings
For Use In Classified Hazardous Locations
Sira 10ATEX 1068U
IECEx SIR 10.0057U
Ex d IIC Gb, Ex t IIIC Db IP66
French/Spanish/German/Portuguese
II 2GD
0539