Maxair 2590-05 User Instructions

CAUTION
!
Before use, thoroughly read MAXAIR
and available at www.maxair-systems.com).
Symbol Definitions
!
Warning, Caution, or Note
REF
Catalog Number
!
WARNING
Failure to follow User Instructions P/N 03521015 and the instructions
contained herein may be hazardous to the user's health.
Use only if package is received unopened and contents are
undamaged. If damage is noted, contact the shipper for replacement
or repair.
Prior to using any MAXAIR
®
familiar with the system's NIOSH approved configuration.
DO NOT use if any component is damaged. If any components are
damaged or contaminated and therefore unfit for safe and effective
use, they should be replaced immediately.
Only trained and experienced personnel who have read and
understand the User Instructions should use MAXAIR Products.
The institution using this product in any application is responsible
for determining the appropriateness of this equipment relative to
regulatory requirements. Bio-Medical Devices Intl, Inc. does not
recommend the appropriate systems for a particular institution or
facility.
Use only MAXAIR Systems/ NIOSH approved compatible
components.
NOT for use in atmospheres immediately dangerous to life or health
(IDLH), and atmospheres containing less than 19.5% oxygen, or
more than 25% oxygen.
Flammability Level I: fabric may burn if exposed to open flame.
Follow current local regulations governing biohazard waste to safely
dispose of single use MAXAIR Products.
If you need more information, contact your BMDI Sales
Representative, or call BMDI customer service at 1-800-443-3842.
User Instructions
®
REF
REF
P/N
NIOSH Number
System or component, be sure to be
CAPR ® P/N 03521015 User Instruction (received with all CAPR Helmets
Intended Use
The MAXAIR Power Cords connect a MAXAIR Systems Belt
Mounted Li-Ion Battery to a MAXAIR Systems Helmet.
2590-05
Specifications
(59 inch)
Material
Cord Cover: White PVC
2590-08 Electrical Connections
Both Connectors:
(47 inch)
Recommended System Temperature Limits
Use/Handling: 0
Charging: 0
Storage: 0
Regulatory
NIOSH
CAUTION
!
The 2590-05 and 2590-08 Power Cords are for use with
2500 Series MAXAIR LI-Ion Batteries (LIBs). Older Power
Cords do not have the correct connector. The 2590-05 and
2590-08 are compatible with older style MAXAIR LIBs.
The older cords do not connect reliably with the 2500 Series
LIBs and must not be used
on 2070-03 and 2075-03 Helmets Only
When you purchase a 2500 Series LIB you will receive new power
cords for each of the MAXAIR Helmets you have purchased over
time. You must discard all older power cords when you receive your
new 2500 Series LIBs to ensure you are always using the correct
connector, regardless of newer or older battery.
1. Firmly grasp the
flat sides of the
older Power
Cord-to-
Helmet
Connector.
Helmet to Battery
C to 54 C at a maximum 80% Relative Humidity.
o 0
C to 45 C at a maximum 80% Relative Humidity.
o 0
C to 35 C at a maximum 80% Relative Humidity.
o 0
with
Exchange Power Cords
2. Firmly lift the
Power Cord-to-
Helmet
Connector up
and out of the
Helmet
receptacle.
Power Cords
these new LIBs.
3. Place the
newer Power
Cord-to-Helmet
Connector into
the Helmet
receptacle
and push in
until it is firmly
seated.
P/N 04123002 Rev A Page 1