Advertisement
Quick Links
5. Maintenance and Repair
WARNING: If the power cord is damaged this must be replaced immediately to avoid
danger. Please follow all other maintenance procedures as shown in picture 8.
6. Diagnos�c List / Fault Finding
Common Issues
Causes of Issues
Pump won't start up
Power supply is not well con-
nected
Electric connector is damaged
Bearing blocked the pump's
running
There is impurity in the pump
There is noise in the
The pump flow is too high
system
There is gas in the pump
There is noise in the
There is gas in the pump
pump
The inlet hydraulic pressure is
too low
Remedy
Check that the fuse or the plug has not come loose
Replace electric capacitor
Make it run in a high speed in a short �me or loosen the
rotor with a screwdriver at the end of the sha�
Disconnect pump to clean it
Change pump to a lower speed
Release the gas
Release the gas
Increase the hydraulic pressure of inlet or check gas
volume in the enlarged slot
BRZPUMP
Bronze Bodied Domes�c Hot Water Circula�on Pump
Installa�on and Opera�on Manual
Please retain for future reference.
Advertisement
Summary of Contents for Tower Hobbies BRZPUMP
- Page 1 WARNING: If the power cord is damaged this must be replaced immediately to avoid danger. Please follow all other maintenance procedures as shown in picture 8. BRZPUMP Bronze Bodied Domes�c Hot Water Circula�on Pump 6. Diagnos�c List / Fault Finding...
- Page 2 1. Informa�on about this Manual 4. Installa�on Read this manual completely and carefully before star�ng to use this device. The manual Pump must be installed in a horizontal posi�on, shown in picture 3 contains important informa�on about the intended use of the device. Especially observe the The pump must be installed according to the procedures shown in picture 4.
Need help?
Do you have a question about the BRZPUMP and is the answer not in the manual?
Questions and answers