Table of Contents
Advertisement
4
GETTING STARTED
1
Connect the AC Power Cord to the AC Input of the 21" Flat Screen CRT / DVR
Combo and plug into an electrical outlet. Connect the cameras into the camera inputs
(BNC or DIN) found on the back of the Unit.
Plug one end of the Ethernet cable into the Ethernet Port of the 21" Flat Screen CRT /
DVR Combo and the other end into an open Ethernet port of the router.
Turn the Main Power Switch ON.
When power is applied, the unit will go through an internal diagnostic test. You will see...
followed by...
then..
POWER ON CHECK _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _OK
HDD IDENTIFY CHECK _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ OK
HDD R/W CHECK _ _ _ _ _ _ _ __ _ _ _ _ _ _ _ _ _ _ _ _OK
MODEL
HDD LBA
HDD SPACE : 160 GB
NOTE:
The unit is equipped with a 160GB MASTER HDD. If the MASTER HDD is not
properly connected, the system will report a "FAIL" message. If this occurs, switch off
the power to the unit and reconnect the HDD into the HDD Cartridge.
System Check.....
Dynamic IP Request . .
***
MASTER HDD DETECT ***
: XXXXXXXXXXXXXXXXXXXXXX
: XXXXXXXXXXXXXXXXXXXXXX
OK
100 %
5
Hide quick links:
Advertisement
Table of Contents
