Summary of Contents for Teac FC5025
- Page 1 Device Side Data Model FC5025 USB 5.25" Floppy Controller Installation and Operation Manual $Date: 2013−03−07 23:26:52 $...
- Page 2 The red stripe on the floppy cable should be on the side nearest the USB connector. The FC5025 is designed to install in a hard disk bay. The top side of the board is the side with the connectors, and the brackets are on the bottom side.
-
Page 3: Drive Select
Jumper settings for TEAC FD−55GFR−7149, FD−55GFR−7193 and FD−55GFR−7220 Setting Description D1 closed, DRIVE SELECT 1 D0,D2,D3 open U0, U1 open DRIVE SELECT turns on front panel LED IU open No IN USE input DC closed, Pin 34 is DISK CHANGE output... - Page 4 If you have GTK 2.x, cd to xdib and run "make −f Makefile.gtk2". To allow users in group floppy to access the FC5025, copy 025_fc5025.rules to /etc/udev/rules.d/ and reboot. Installing the included software − Mac OS X To install MacDIB, navigate to the Drivers folder on the included CD−ROM,...
- Page 5 Installing the included software − Windows 98SE If you boot your computer with the FC5025 connected before installing the drivers, the Add New Hardware Wizard will appear. If this happens, cancel the wizard. To install the drivers, navigate to the Drivers folder on the included CD−ROM and double−click FC5025_Windows_Setup.
- Page 6 Windows, open the USB Floppy program group in the Start Menu and click on Disk Image and Browse. If you have more than one FC5025 connected, you may select which one you want to use. Select the type of disk you want to read. You can then either...