"Dn" Clock Display Mode - Electronics International Super Clock SC-5 Operating Instructions Manual

When the Up Timer has reached 59 minutes and 59 seconds, the display will switch from minutes and
seconds to hours and minutes and an "/Hr" will appear in the upper right corner of the display. Anytime
you see an "/Hr" in the display the reading is in hours and minutes; otherwise, it is in minutes and sec-
onds.
To program the Recurring Alarm, perform the following steps while in the "UP" Timer Display Mode:
A. Momentarily push both the "START/STOP""and "RESET" Buttons at the same time. The"far
left digit will "blink."
B. Set the Recurring Alarm using the following procedure.
a) Select the Digit to be programmed - Only the digit that is blinking can be changed.
Push the""START/STOP" Button to "blink" the next digit to the left and push the "RE-
SET" Button to""blink" the next digit to the right.
b) Increase or Decrease a Blinking Digit - Move the "STEP" Switch to the right to in-
crease the blinking digit by one. Move the "STEP" Switch to the left to decrease the
blinking digit by one.
c) To Exit - To exit the "UP" Timer Programming Mode, momentarily push bot hthe
"START/STOP" and "RESET" Buttons at the same time.
8. "DN" Timer Display Mode:
By pushing the "STEP" Switch to the right or left, you can select the various display modes. In the
"DN" Timer Display Mode, the SC-5 will display the current time on the "DN" Timer. Push the "RE-
SET" Button to stop the Timer and reset the time to the programmed Start Time. Push the "START/
STOP" Button to toggle the start and stop of this Timer.
The "DN" Timer has a pilot programmable Start Time. The Start Time may be set from 0:00 to 99:59
"(minutes: seconds). For time set over 59 minutes and 59 seconds the Down Timer will display in hours
and minutes and an "\Hr" will appear in the upper right comer of the display. Anytime you see an "/Hr"
in the display, the reading is in hours and minutes; otherwise, it is in minutes and seconds.
10