Date: 20/7/2022 Version Number: 2022 Issue no.2 Contents The Chadwick Stove Collection............................4 1. Identifying your stove..............................5 1.1 Identifying parts & terminology of your stove-External................... 5 1.2 Identifying parts & terminology of your stove-Internal..................6 2. Warnings..................................7 2.1 Important Warnings............................7 3.
Page 3
Date: 20/7/2022 Version Number: 2022 Issue no.2 13.3 Chimney fires..............................25 13.4 Periods of non-use (summer months)......................25 13.5 Multi Fuel Kit Optional Accessories......................26 13.5.1 Riddling the firebox........................... 26 13.5.2 Ash removal............................26 13.6 Replacement parts............................27 13.7 Classification..............................27 13.8 Adverse weather conditions.......................... 27 13.9 Door glass..............................27 13.10 Fire door handle............................27 14.
Date: 20/7/2022 Version Number: 2022 Issue no.2 The Chadwick Stove Collection Congratulations on the purchase of your new stove! More than 30 years of experience has been put into the development of your stove to ensure ultimate performance and years of trouble-free use and enjoyment. Every detail of your stove has been carefully designed and engineered which is why we are so confident in the reliability of our products.
Date: 20/7/2022 Version Number: 2022 Issue no.2 1. Identifying your stove 1.1 Identifying parts & terminology of your stove-External Top Flue Outlet (NOTE: Top & Rear Flue outlets are Fire Door Interchangeable & Assembly Will Depend Upon Installation.) Fire Door Handle Air Controls Rear Flue Outlet...
Date: 20/7/2022 Version Number: 2022 Issue no.2 1.2 Identifying parts & terminology of your stove-Internal Firebox Liners (Sides & Rear) Fuel Retainer 2. Warnings Fire Door Glass Secondary Air Control Tertiary Outlet Throat Plate Primary Air Control Tertiary Air Control Page...
Date: 20/7/2022 Version Number: 2022 Issue no.2 2. Warnings 2.1 Important Warnings It is a LEGAL REQUIREMENT that the installation of all new or replacement, wood, or solid fuel heating appliance(s), obtain building control approval, from your local authority or that the installation work must be carried out through a government approved competent person’s scheme.
Date: 20/7/2022 Version Number: 2022 Issue no.2 4. Installation Requirements 4.1 Hearths and Recesses The stove should be installed on a surface with adequate load bearing capacity. If the existing construction does not meet this prerequisite, suitable measures (e.g. load distributing plate) should be taken to achieve it.
Date: 20/7/2022 Version Number: 2022 Issue no.2 4.3 Air For Combustion All stoves require ventilation to burn safely and correctly. There are a number of requirements that need to be met when installing a stove, for example, allowing for the permeability of the house (air permeability is the general seepage of air into the house via air vents, doors, and windows etc.) There must always be a permanent means of providing air for combustion into the room in which the stove is installed.
Page 10
Date: 20/7/2022 Version Number: 2022 Issue no.2 problems. If a new chimney is being provided it should fully comply with the relevant Building Regulations that specify the requirements for solid fuel burning installations. Suitable types of chimneys include the following: ·Masonry Chimney: Built with clay or concrete liners, or a chimney block system meeting Building Regulations.
Date: 20/7/2022 Version Number: 2022 Issue no.2 6. Installing The Stove To make the stove easier to maneuver (and safer) we recommend you remove the following parts which can then be refitted when the stove is in its final position: Liners, Door (To help prevent the glass from breaking), Operating Tool, Ash pan, Throat Plate&...
Date: 20/7/2022 Version Number: 2022 Issue no.2 4: Fit the retainer bar and ash pan as shown. 5: Fit the back external air inlet with the set screws and gaskets. 6.2 Removing the throat plate and liners The throat plate rests on the rear liner and ledge within the upper edge of the door aperture. Push up on the mid part of the throat plate with the palm of one hand.
Date: 20/7/2022 Version Number: 2022 Issue no.2 requirements. Fitting is simply done using the supplied M6 nuts and washers (no bolts are required as studs are factory fitted to the hot plate disc). Again fire cement can be used in conjunction with the self-adhesive rope seal.
Date: 20/7/2022 Version Number: 2022 Issue no.2 NOTE: The minimum air control setting is governed in manufacture to meet their requirements of Smoke Control exemption and as a result the appliance will NOT shut down completely when in the minimum air position setting. Restrictor Screw Restrictor Screw Removed...
Date: 20/7/2022 Version Number: 2022 Issue no.2 Check the flue draught which should read 10-20pa, or 0. 1-0. 2 mbar. Consult a suitably qualified person who will have the knowledge and equipment to perform a test. For a registered Competent Persons scheme (such as those referred to at www.gov.uk/building- ...
Date: 20/7/2022 Version Number: 2022 Issue no.2 Do not use aerosol sprays or any other flammable materials near the appliance when in use. Do not use the appliance as an incinerator. Use only recommended fuels, STRICTLY NO unsuitable and non-recommended fuels or materials or liquid fuels allowed.
Date: 20/7/2022 Version Number: 2022 Issue no.2 section 50 of the Regulatory Reform (Scotland) Act 2014. Similarly in Northern Ireland appliances are exempted by publication on a list by the Department of Agriculture, Environment and Rural Affairs under Section 16 of the Environmental Better Regulation Act (Northern Ireland) 2016.
Date: 20/7/2022 Version Number: 2022 Issue no.2 For additional advice on fuels, please refer to the Solid Fuel Association(www.solidfuel.co.uk) DO NOT BURN Bituminous house coal or petroleum coke in this appliance. PLEASE NOTE: All test data, outputs and efficiencies stated in this instruction manual were obtained by burning 'Maxibrite' mineral smokeless fuel.
Date: 20/7/2022 Version Number: 2022 Issue no.2 Air inlet controls 11.1 Air Inlet Your stove requires air to function, this enters at the bottom rear of the appliance. Depending upon installation, an optional direct air kit can be purchased as the connection point for the direct air feed/ducting, installation requirements.
Date: 20/7/2022 Version Number: 2022 Issue no.2 Fig. 3. Fully Open Position Fig. 4. Fully Closed Position 11.1.2 Secondary air control The secondary air control regulates the air entering the fire box chamber, supplying an over draught of air to the fuel bed, together with supplying air in front of the glass viewing panel within the door assembly.
Date: 20/7/2022 Version Number: 2022 Issue no.2 NOTE: If your stove installation is within a smoke control area, it will be fitted with a restrictor plate acting as a mechanical stop for the secondary air control. This will not fully close,thus allowing a bleed of air to the fire box to reduce smoke emissions.
Date: 20/7/2022 Version Number: 2022 Issue no.2 Lighting your stove 12.1.1 Smoke control areas Please check whether your dwelling is located in a smoke control area before installation or use. Please check with your local authority or https: //www.gov.uk/smoke-control-area-rules. 12.1.2 Fuel overloading The maximum amount of fuel specified in this manual should not be exceeded, overloading can cause excess smoke.
Date: 20/7/2022 Version Number: 2022 Issue no.2 A reduced setting may also be required on the secondary air control, to maintain clear glass on the door assembly. Riddling the stove occasionally will also help to ensure that burnt fuel does not prevent the supply of air from reaching the fuel bed.
Date: 20/7/2022 Version Number: 2022 Issue no.2 Do not attempt to re-light the fire until the cause of the fume emission has been identified and corrected. 12.5 Refueling on to a low fire bed If there is insufficient burning material in the fire bed to light a new fuel charge, excessive smoke emission can occur.
Date: 20/7/2022 Version Number: 2022 Issue no.2 Further information for all stove owners 13.1 Reduced burning (Slow Combustion) When wood is burnt slowly in a closed appliance (e.g.: air controls at the minimum setting) , it produces moisture and tar, which will create condensation and deposits in the chimney. This effect can be minimised by burning hard for a short period, fifteen to twenty minutes twice a day.
Date: 20/7/2022 Version Number: 2022 Issue no.2 13.5 Multi Fuel Kit Optional Accessories 13.5.1 Riddling the firebox To riddle the grate, the main fire door will need to be open, carefully open the fire door. Multi Fuel Kit Optional Accessories mounted riddle lever, using the glove, move the lever left to right, repeatedly, until the ember/ash bed has been reduced.
Date: 20/7/2022 Version Number: 2022 Issue no.2 13.6 Replacement parts Genuine replacement spare parts can be obtained from your Flue & Ducting retailer/dealer. You can find a complete list of spares and consumables such as liners, replacement grate parts and throat plates as well as items to enhance its visual appearance and efficiency such as stove paint and rope kits.
Date: 20/7/2022 Version Number: 2022 Issue no.2 Care for your stove The need for regular maintenance on your stove will ensure, safe and efficient use of your appliance. The following item listing should be checked and inspected by a competent person or engineer on a regular basis.
Date: 20/7/2022 Version Number: 2022 Issue no.2 14.6 Chimney/Flue Sweeping Sweeping should be carried out with an appropriately sized bristle brush and rods to suit chimney size and type. As with all appliances regular sweeping of the flue/chimney is essential to avoid dangers of blockage and the escape of poisonous fumes.
Date: 20/7/2022 Version Number: 2022 Issue no.2 Chadwick stoves come with a LIFETIME warranty to the main body of the stove. The external paint finish carries a one-year guarantee only. This guarantee is subject to the Terms and Conditions set out below. 16.2 Terms and Conditions The following terms and conditions must be satisfied in order for your stove to be covered by the guarantee set out above:...
Date: 20/7/2022 Version Number: 2022 Issue no.2 10. The guarantee is only valid if the stove is serviced and checked annually by a suitably qualified heating engineer, with documentation to be retained and produced in the event of a claim being made. 11.
Date: 20/7/2022 Version Number: 2022 Issue no.2 Technical Drawings and Performance Date The Chadwick Chadwick Wood – Primary Fuel Smokeless Fuel Nominal Heat Output 4.6 kW 6.2 kW Energy Efficiency 75.6 % 79.9 % PM at 13% O2 30 mg/m3 27 mg/m3 OGC at 13% O2 120 mg/m3...
Page 33
Date: 20/7/2022 Version Number: 2022 Issue no.2 Declaration of performance according to Regulation (EU) 305/2011 Ref No: FL-Chadwick-CPR-2021-12 Point Flue & Ducting room heater burning solid fuel without supply of Product Type hot water in accordance with EN 13240:2001 Product model designation The Chadwick, Serial No.
Page 34
Date: 20/7/2022 Version Number: 2022 Issue no.2 Flue & Ducting Total Chimney Solutions Flue & Ducting Ltd Unit D6 Yew Street Stockport Trading Estate SK4 2JZ United Kingdom www.flue-ducting.co.uk T: +44 (0)161 480 2994 Email:sales@flue-ducting.co.uk...
Need help?
Do you have a question about the Axon Chadwick and is the answer not in the manual?
Questions and answers