Page 1
3/16” AIR HYDRAULIC RIVETER CT0057 Ref no. RD-F2014 ORIGINAL INSTRUCTIONS Cannon Tools Limited Address: 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K. SAVE THESE INSTRUCTIONS AND PRECAUTIONS. READ ALL PRECAUTONS AND INSTRUCTIONS BEFORE USE.
In case of alteration of the machine, not agreed upon by us, this declaration will lose its validity. Product description: AIR HYDRAULIC RIVETER Model: CT0057(Ref no. RD-F2014) Applicable EC Directives: EC Machinery Directive 2006/42/EC Harmonized standards EN ISO 11148-10:2011 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K.
SAFETY INSTRUCTIONS WARNING! Ensure that Health & Safety, local authority and general workshop practice regulations are adhered to when using this equipment. Familiarise yourself with the applications, limitations and potential hazards peculiar to the riveter. WARNING! Disconnect the riveter from the air supply before changing accessories, servicing or performing any maintenance.
SPECIFICATIONS Max. air pressure: 6.3bar Air inlet: 1/4" Air consumption: 3CFM @ 6.3bar Max. rivet capacity: 3/16" Stroke length: 9/16"(14mm) AIR SUPPLY The recommended air system is shown in fig. 1. 3.1. Ensure that the trigger is in the "Off" position before connecting to the air supply. 3.2.
Page 5
Refit and tighten the air cylinder cap. Adjusting the stroke: Check that the hydraulic level is correct. Remove the frame head using the spanner provided. Check the jaw stroke by using the supplied spanner/gauge as in fig. 3. ...
MAINTENANCE WARNING! Ensure you disconnect the tool from the air supply system before attempting any service or maintenance. 1. Maintain the tool with care. Keep it oiled for optimum performance. 2. Lubricate the air tool daily with a high quality air tool oil either via an oiler in the air supply system or by placing a few drops into the riveter air inlet immediately before use.