Summary of Contents for Abrams EH-100
- Page 1 Expedition Series Remote Siren System MODEL EH-100 INSTALLATION AND OPERATION INSTRUCTION...
-
Page 2: Instruction Of Operation
Warning Light Control …………… 2 levels The EH-100 must be installed under the seat, in the truck or on the dash of OUTPUT 1……………10A maximum any vehicles with 12 volts, negative ground chassis system. Connection OUTPUT 2……………10A maximum... - Page 3 Improper use of the speaker or of its installation will reduce the efficiency of sound output, which results in degrading the alert effectiveness. Be also aware that the use of EH-100 does not give you the right to force your way through...
- Page 4 HANDHELD CONTROLLER 5. AIR – The momentary button. With no siren sound, depressing All controls utilized during normal operation of the EH-100 are located on the this button once creates "Air Horn" sound. The sound ceases as soon handheld controller.
-
Page 5: Installation
File a claim immediately with the The installer then should ensure that the equipment is installed carrier stating the extent of the damage if the EH-100 has been damaged. only in the areas recommended by the vehicle manufacturer. - Page 6 1/4″of insulation from the end of the wires. Then connect the insulation from the end of the wires. Then insert the wire into wire to the connectors on EH-100. Connect the red wire to "POS+" the quick-on connector (supplied) and cramp securely with position and black wire to the "NEG-"...
-
Page 7: Testing After Installation
To properly service an electronic siren, you must have a good understanding of automotive electrical systems and emergency signaling procedures. Most of the components and electronic parts used in the model EH-100 are standard items that can be obtained from any electronics supply shop. To reduce equipment down-time, the factory recommends that the entire amplifier’s printed circuit board (part No. - Page 8 Make certain that the speaker(s) is (are) not defective before reinstalling the repaired EH-100. After servicing is complete, perform a test of all functions to ensure siren is operating properly. Whenever the siren is tested, be aware of...