Set Activation Point; Auto Mute Mode; Voice Or Tone Mode; Customizable Display Colors - Cobra XRS 9945 Operating Instructions Manual

Settings
Your Detector
Intro Operation Customer Warranty

Set Activation Point

Assistance
After the detector is installed in your vehicle and IntelliMute or IntelliMute Pro
Main Icons
is turned On using Menu mode, press the City
IntelliMute Set Point screen where the Activation Point can be set.
Secondary Icons
At the Set Point screen:
Intro Operation 1. Press the Mute Customer Warranty button to advance to the Setup screen.
Assistance
2. Press and hold the vehicle accelerator at the desired engine RPMs.
3. Press the Mute button to complete the setting process.
Notice
The system will store the engine RPM setting and provide a completion
Secondary Icons
message on the display as well as a tone or voice message.
NOTE
If the unit is unable to sense usable pulses within three seconds or if you
ain Icons
do not set a rev point within 30 seconds of beginning the setup, IntelliMute or
Notice
IntelliMute Pro will indicate an error. If you do not try again within five seconds,
it will automatically turn Off. The unit will provide corresponding messages for
these conditions.
ain Icons
Intro Operation Customer Warranty
Once an activation point has been set, you can easily change it by going
Assistance
to IntelliMute / IntelliMute Pro in User Settings Menu and repeating the
three-step setup process.
If, for any reason, the unit stops sensing your engine's revs, IntelliMute or
Intro Operation Customer Warranty
econdary Icons
Assistance
IntelliMute Pro will indicate an error and automatically turn Off.
NOTE
When initially choosing your IntelliMute or IntelliMute Pro Activation Point,
Operation Customer Warranty
econdary Icons
Assistance
Notice a setting of approximately 300 to 600 RPMs above idle is recommended.
NOTE
Customer
Installation The rev point must be reset if you use your detector in a different vehicle.
Assistance
Notice
CAUTION
Do not attempt to set the rev point while driving. Your vehicle should be
parked and idling to avoid a collision during the process.
Notice Caution Warning
18 English
Your Detector
Intro

Auto Mute Mode

When Auto Mute is On, it automatically reduces the audio volume of all alerts
after they have sounded for four seconds. The signals will remain muted for as
button to advance to the
long as the signal is detected. When Auto Mute is Off, the alerts will sound at
full volume for as long as the signal is detected. The factory setting for Auto
Secondary Icons
Mute is On.

Voice or Tone Mode

You can set your detector to sound alerts and confirm menu settings with
either a Voice or a Tone Alert. Voice Alert provides voice messages in addition
to tones. Tone Alert provides tones only. The factory setting is Voice Alert.

Customizable Display Colors

Your detector includes the Color Theme feature that allows you to customize
the display screen color scheme to match your car's dash illumination:
Multi-Color, Red, Blue, Orange or Green. The factory setting is Multi-Color.

Display Timeout

Display Timeout determines how long the Standby screen is illuminated
before switching the unit to Dark. The factory default is 30 seconds.
You can set the time interval to 15 seconds, 30 seconds, one minute,
three minutes or Always On (display never turns Off).

Frequency Display Mode

Different Ka radar and LIDAR (Laser) guns operate at various frequencies
within their assigned spectrums. When Frequency Display is turned On,
the signal frequency will be added to the alert. The factory setting for
Frequency Display is Off.
Settings
Operation Customer Warranty
Assistance
Notice
Nothing Comes Close to a Cobra ® 19