1. Manuals
  2. Brands
  3. Starcom Manuals
  4. Set-top boxes
  5. IS-5041
  6. Self-install manual

Starcom IS-5041 Self-Install Manual

Hide thumbs
1
2
3
4
5

Advertisement

Table of Contents

To ensure the successful installation of your IS-5041 STB, read and follow the step-by-step
instructions below.
1. Do you have all of the necessary equipment?
a. IS-5041 STB
b. Remote Control (This remote control is already programmed to operate your STB.
Instructions on how to program your remote to operate your TV or other devices are
available from your service provider.)
c. HDMI Cable
d. Power Cord
Power Cord
HDMI Cable

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IS-5041 and is the answer not in the manual?

Questions and answers

Summary of Contents for Starcom IS-5041

  • Page 1 To ensure the successful installation of your IS-5041 STB, read and follow the step-by-step instructions below. 1. Do you have all of the necessary equipment? a. IS-5041 STB b. Remote Control (This remote control is already programmed to operate your STB.
  • Page 2 Make sure your TV is turned off. Connect the HDMI cable from the HDMI port on the back of the STB to the HDMI input on your TV. Turn on your TV. Make sure that your TV is set to the proper input. Plug one end of the STB power cord into the STB, and then the other end into the power outlet.
  • Page 3 Enter the WiFi password. The STB will connect to the network and finish STB setup automatically. In a few seconds, the new settop box should indicate that it has connected. As your STB loads, you will see a welcome screen indicating the STB is loading. NOTE: The Electronic Program Guide usually will appear in 30-60 minutes after first network connection.
  • Page 4 To STB These are sent out generic and not programmed to any one STB. No flashing or missing code on these remotes. It sounds like they never programmed the remote for the 5041w. Here are the steps to program the remote for the 5041w. To pair the remote to the Set-Top-Box Hold SETUP until the STB key blinks twice.
  • Page 5 To TV Code Method 1. Turn on a device 2. On the remote control, press a device key onc(i.e., VCR, DVD, AUD, TV, or STB); it will blink once. 3. Press and hold SETUP until the selected mode key blinks twice, then release SETUP. 4.

Table of Contents