Do you have a question about the WK090802 and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for Woodbridge WK090802
Page 1
INSTALLATION AND CARE GUIDE WOODBRIDGE KITCHEN FAUCET WK090802 Certified to the following Codes & Standard: • ASME112.18.1-2018/CSA B125.1-18 • NSF/ANSI/CAN 61-2018 ® READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT This products must be installed by a fully insured and licensed plumber only. Installation of any our product by anyone other than fully insured and licensed plumber shall void limited warranty.
Page 2
WOODBRIDGE KITCHEN FAUCET DIMENSION DRAWINGS: 2-5/8" 8-3/4" 1-1/4" 9-5/8" YOU MAY NEED www.woodbridgebath.com...
Page 3
WOODBRIDGE KITCHEN FAUCET PARTS & COMPONENTS PARTS: Component Body Washer Spray Head Cartridge Press Hat Handle Screw Canopy deck plate Screwed Pipe O-Ring Washer Washer Lock Nut Pilot Sleeve Washer Flexible Hose Flexible Hose Flexible Hose Hose Weight TROUBLE-SHOOTING If you’ve followed the instruction carefully and your faucet still does notwork properly, take these corrective steps.
Page 4
WOODBRIDGE KITCHEN FAUCET INSTALLATION PROCEDURES Rubber Washer Metal Washer Locknut You should clean all the dirts from valve outlets. Installation without deck plate, make sure the O-Ring is placed Turning off the water supply valves.This is usually into the bottom of base ring, install faucet through hole on sink.
Page 5
WOODBRIDGE KITCHEN FAUCET INSTALLATION PROCEDURES After installation is complete, remove Spray head Replace Spray head. and rotate handle to the close position. Turn Water Supply Valves on, and check all connections for leak. Flush faucet by running hot and cold water in full position for one minute.
Need help?
Do you have a question about the WK090802 and is the answer not in the manual?
Questions and answers