Advertisement
MP Loudspeaker Quick Start Guide
Choose the Speaker Location:
.
Thank you purchase this MP product, like all of our
product, if installed correctly, these speakers will
bring you years of outstanding listening enjoyment.
This On-wall speaker can be mounted either horizontally
or vertically with almost identical performance.
Place the left and right speakers on either side on the
Video screen. You should try to place the tweeter as
close to ear level as possible.
Ideally you want to place the center channel at the
same level as the left and right speakers. If you must
place the center channel above or below the screen,
keep the distance to a minimun between L/R.
Mounting the Speaker:
.
INSTALL & REMOVE THE G
After determing the best location for the speaker, use
the attached four Mounting bracket to install the speaker
on the Wall.
We also Prepar four M6 threaded insert behind the box
as your more options.
Warning:
.
Make sure to observe polarity, R + (positive) from the
amp or volume control to speaker R + and R – (negative)
to R –. Make sure to do the same for the left channel.
When connecting the other end of the speaker cable to
the amplifier or receiver make sure to observe the same
polarity as you did at the speaker connection.
Put the speaker into the hole (the speaker cable should
be connected) and make sure the speaker cable stays
connected to the speaker.
Carefully tuck the speaker cable up into the hole as you
put the speaker into place.
All manuals and user guides at all-guides.com
.
Prepare before Speaker Installation:
.
If the home pre-wired for speakers at construction time,
There should also be speaker cable at this location.
After the drywall is installed and the hole is cut, the speaker
is then easily installed. Once the hole is cut in the drywall,
the pre-wired speaker cable should be in the wall near the
hole. If rough-in speaker rings were used, move on to
"Speaker Installation".
Find the location to where the speaker wire was pre-wired
to. Locate the wood studs or joists nearest the desired loca
-tion and make sure they will not interfere with speaker loca
-tion.
Mark small holes in the center of your outline 4 pcs mounting
brackets. If there are no problems with your mounting loca
-tion, proceed and drill the holes, put screw in. At this point,
you should be able to see or find the speaker cable.
Speaker Installation:
These speakers are mono so you will need two speakers for
stereo sound,one for the right channel and one for the left.
There should be a two conductor speaker cable pre-wire to
each of the speaker locations. Make sure you find each of t
he speaker cables and pull them though the cut speaker
holes.
Remove the speaker from the box and inspect for any
damage. If there is any damage, contact MP Dealer
immediately.
Prepare the Speaker cable:
You should have located the speaker cable by now, so it's
time to prep it for connection to the speaker. Strip back the
outside insulation so the individual conductors are showing.
Depending on the cable, there should be two or four separate
conductors. Strip back the insulation on each conductor to
show the bare copper wire.
We suggest stripping enough so that 3/8" of copper wire is
showing. Push down each post and insert the speaker cable.
The posts will be located on the back of the speaker on the
crossover. Make sure that only BARE wire is touching the
speaker post once it slides back into place.
www.marnap.com
Advertisement
