Table of Contents
Advertisement
Remote controller
Selecting mode
Each time
the "MODE"
operation mode is changed in sequence:
COOLING
DRY
FAN ONLY
Heating mode is NOT available for cooling only air conditioner.
FAN mode
Each time the "FAN" button is pressed, the fan
speed is changed in sequence:
Auto
Higher
High
At "FAN ONLY" mode, only "Higher","High","Medium""Low"
and
"Lower" are available.
At "DRY" mode, Fan speed is set at "Auto" automatically, "FAN"
button is ineffective in this case.
Setting temperature
"＋" Press once to raise temperature setting by 1℃
"－" Press once to lower temperature setting by 1℃
Range of available set temperature
*HEATING, COOLING
Note: Heating mode is NOT available for cooling only models.
Note: Press and hold "
together for 3 seconds will alternate the temperature display
between the ℃ and °F scale.
Turning on
Press ON/OFF button, when the appliance
receives the signal, the RUN indicator of the
indoor unit lights up.
SWING, SMART, TIMER ON, TIMER OFF, CLOCK,
SLEEP
and SUPER
operation modes will be
specified in the following pages.
Changing modes during operation, sometimes the unit
does not response at once. Wait 3 minutes.
During heating operation, air flow is not discharged at the
beginning. After 2－5 minutes, the air flow will be discharged
until temperature of indoor heat exchanger rises.
Wait 3 minutes before restarting the appliance.
button is pressed, the
AUTO
HEATING
Medium
Low
Lower
16℃-30℃
" button and "
" button
TEMP
Airflow direction control
Vertical airflow(Horizontal airflow) is automatically
adjusted to a certain angle in accordance with the
operation mode after turning on the unit.
Operation mode
COOLING, DRY
*HEATING, FAN ONLY
The direction of airflow can be also adjusted to
your own requirement by pressing the "SWING"
button of the remote controller.
*Heating mode is only available for heat pump models.
Vertical airflow control
Using remote controller to set various angles of flow
or specific angle as you like.
Swinging airflow
Pressing
button once, the vertical adjustment
louver will swing up and down automatically.
Desired direction airflow
Pressing the
swing to a suitable angle as desired.
Horizontal airflow control
Using remote controller to set various angles of flow
or specific angle as you like.
Swinging airflow
Pressing
button once, the horizontal
adjustment louver will swing left and right
automatically.
Desired direction airflow
Pressing the
button again when the louvers
swing to a suitable angle as desired.
NOTE:This function is to keep global
format standardization and for this model
isn't available. You can adjust the
horizontal airflow by yourself
Do not turn the vertical adjustment louvers manually,
otherwise malfunction may occur. If that happens,
turn off the unit first and cut off the power supply,
then restore power supply again.
It is better not to let the vertical adjustment louver tilt
downward for a long time at COOLING or DRY mode
to prevent condensed water from dripping.
2
Direction of airflow
horizontal
downward
button again when the louvers
Advertisement
Table of Contents
